HASBRO OX4 User's Manual

[I

Using a PhiltipsJcross R e a d screwdriver

( n o t i n c l u d e d ) , loosen screw in battery c o m p a r t m e n t c o v e r (screw stays attached to cover). Insert 4 x 1.5V 'C' or LRl4 aUtclline size batteries (not included) intc

I

A

CAUTION: TO AVOID BATTERY LEAKAGE

1. Be sure to

insert

the

batteries correctly

and

always follow the toy

and

battery manufacturers' instructions;

2. Do not mix

old batteries

and new

batteries

or

alkaline, standard (carbon-zinc)

or

rechargeable

(nickel-cadmium) batteries;

3. Always remove weak

or dead

batteries

from the

product.

IMPORTANT: BATTERY INFORMATION

Please retain this information for future reference.

Batteries should be replaced by an adult.

A

CAUTION:

1. Always follow the instructions carefully. Use only batteries specified and be sure to insert item correctly by matching the markings.

+ and

- polarity

2. Do not mix old and new batteries or standard (carbon-zinc) with alkaline batteries.

3. Remove exhausted or dead batteries from the product.

4. Remove batteries if product is not to be played with for a long time.

5. Do not short-circuit the supply terminals.

6. Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset

"51

(switching off and back on again or removing and re-inserting batteries) if necessary.

7. RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. Always remove from the product before recharging.

Recharge batteries under adult supervision. DO NOT RECHARGE iR TYPES OF BATTERIES.

I

.......................................

..............i i

.

Volume

- .

,

5 ' =

.

. .

.

-

. .

, '

--

. ,

,:J

-

~

5

-

-

8

,

; 5 -

-

..

.- ,

.

-

--

~.

~ ! J

- .

4

,

--+z

_ _ I

.

,

.

.

.:.;

? :.

:-

.?;

. .

..,.=?

#,.'i

; L

Before you plug u w x p l u g anything in or out of the amplifier jacks, turn the amplifier O f f : d 'n*o will avoid a "pop" noise. t

It is also very important to use the INPUT and OUTPUT jacks correctly. Confusing them may harm the connected electronic products. a

To connect the amplifier to your POWER TOURTM Electric

-

44

Guitar (sold separately):

1. Take the cable that came the amplifier 'IN 1" jack. with the amplifier and plug

.

.

:. end

. into

-.

M:

2. Rug the other end of the cable into the "OUT" jack of the guitar,

-1

3. Tlrrn the amplifier ON.

4. May music, adjusting the amplifier volume to your liking. Setting the volume of your .guitar too high may cause distodion in the amplifier. n .

i ..............................................................................................

If you want to use your amplifier as a speaker for your personal music player (CD player, mp3 player, etc. - not included):

1. Plug one end of the encbsed cable into the OUTPUT jack of you personal music player (not included).

2. Plug the other end of the cable into the 'IN 2" jack of the amplifier. Do

NOT insert this cable end into the amplifier's "OUT" jack!

Adjust the amplifier volume to your liking. Setting the volume uf your

D M 0 lnot included) too high may cause distortion in the amplifier. f'-&

;,.

-;- music from your PMP (not included):

1. follow the instructions to connect your POWER TOURTM Electric Guitar

(sold separately) to the amplifier. (p. 3) Use the long cable that came with the amplifier.

2. Take the shorter cable, which came with your POWER TOURTM Elecmc

Guitar (sold separately). and use it to plug your personal music player

(not included) into the amplifier's 'IN 2" jack. Do NOT connect your personal music player (not included) to the amplifier's 'OUT" jack!

3. Adjust the volume settings of your personal music player (not included), guitar (sold separately) and your amplifier to get the appropriate balance of sound to jam along with your tunes.

i

CONNECTbNG

/ S Z A CMNG

POWER TOURmAMPS

If you have a second POWER TOURTM amp (sold separately). you can c two amplifiers. Doing so doubles your sound!

Take the cable that came with the second POWER TOURTM AMP, and plug on into the "OUT" jack of the first amplifier: plug the other end of this cable into the I!

'IN 1" jack of the second amplifier.

Once you have the two POWER TOURTM AMPS connected, you may plac amplifier on top of the other amplifier: you'll see that the four pads on t

-

- of one amplifier fit comfortably into four tabs on the top of the other amplifier.

This does not lock the two amplifiers together: so be careful not to knock or push them over!

Control the tone and volume of each amp with each amplifier's Tone and ~olum& knob. If you have two or more amps connected together, it is a good idea to set each amp at the same volume: this equalizes the sound.

Use the Volume knob on your guitar (not included) to control guitar output. If you kt, ant to play loud, set each amplifier at the same high volume, then turn up the volume of your guitar: use the Tone

. on each of the amps to adjust for the best sound.

If you don't play any music through the amplifier for about 15 minutes. the amplifier w i l l enter a 'sleep state"

(conserving battery life, should you forget to turn the amplifier off). wake the amp back up. play some music through the amplifier. (The amplifier might not pick up low-volume music, so you might have to play a couple of loud notes.) You could also switch the power switch off, then back on again, to wake up the amplifier. If you're not going to play through your amplifier for a while. however, it's best to turn it off, to conserve battery life.

.

:

-L.'=-,.

. : -

. 7

. , -

-

- -

.

-

- -

. . .

.

,,

-. .

.

+

:

--

~

--

.

.

,

--

.

.-

.

---

:?LL+€-~

, .

.

-

.

-. t

:-

, ~ to jam

along

w i t h your personal music player w i t h twoor more amps:

1. Connsct your personal music p l a y e r to t h e guitar (sold separately).

2. Connect t h e guitar t o t h e first amp's 'IN 1" Jack.

3. Connect t h e first amp's OUT Jack t o t h e second amp's IN1 jack.

4. Control t h e input o f your personal music p l a y e r through t h e p b y e r ' s volume setting.

.

, . .,

,

,

,

,

..,

.

. A .

, , .

I Make sure the volume levels of the am~lifier of vour musical device sounds are faint or we

1

The amplifier is acting erra

-m y

(not included) are turned up.

Or, the batteries may need changing. See battery instructions for details

I've changed the batteries, and the on how to change batteries.

Make sure you have installed the batteries correctly. am~lifier not doina anvthina.

The jacks accept only 3.5 mm stereo audio cords. Using mono cables or adapters, combining left and right audio channels, may damage whatever device you plug into the amplifier.

I cannot fit an audio cord into the

INPUT or OUTPUT jack.

Turn the amplifier OFF, wait a few seconds, and then turn it back ON.

I

The amplifier is freezing up.

FCC STATEMENT

This eqyipkwpt has been tested and found to comply with the limits for a Class B digital device, @uf&ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable uses and against h m f u l interference in a residential installation. This equipment generates, exan radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, more of the following measures:

Reorie'rerlt or relocate the receiving antenna.

Increase the separatian between the equipment and the receiver.

Consult the dealer or an experienced r a d i W technician for hdp.

Product and colors may vary. O Hasbro. All Rights

Reserved. TM & Q denote U.S Trademarks. Patent Pending.