Havis-Shields C-TCB-9 Install Instructions

1

1

2

1

1

1

INSTALL INSTRUCTIONS C-TCB-9

1989-2001 JEEP CHEROKEE

TOOLS REQUIRED:

3/16” Allen wrench

3/8” Standard socket set

3/8” Metric socket set

HARDWARE & COMPONENTS:

Ratcheting wrench (3/8” drive)

Powered drill w/ 3/16” drill bit

Open-end wrench set

Pole support assembly

Telescoping pole assembly

Side support brace

5/16” Flat washer

5/16-18 Nylock nut

¼” x ¾”Hex head lag bolt

CM93071-9

CM93072-3

CM93146

GSM31006

GSM30017

GSM33060-1

Always

!

Read all instructions before installing any Havis-Shields Equipment Corp products.

Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

Use hardware provided with install kit

Side support brace

¼” x ¾”Hex head lag bolts

Telescoping pole assembly

Pole support assembly

5/16-18

Nylock nut

Location of passenger side factory seat base bolts

SUB ASSEMBLY:

1. Confirm receipt of all hardware and components.

2. Remove front inner and outer passenger seat bolts on vehicle.

INSTALLATION:

1. Mount C-TCB-9 into vehicle:

• Position pole support assembly between seat base mount and floor of vehicle

• Align holes in pole support assembly with holes in seat base.

• Loosely attached factory seat bolts that were removed during subassembly.

• Mount side support brace to threaded rod located on pole support assembly using a

5/16-18 Nylock nut

• Mount side support brace to vehicle using ¼” x ¾” Hex head lag bolts. A 3/16” pilot is required.

Note: When mounting side support brace to floor of vehicle, be sure to check for obstructions prior to drilling or lag bolting to floor.

• Tighten down passenger side factory seat bolts and 5/16-18 nylock nut holding side support brace to pole support assembly.

• Mount optional C-3090, computer-mounting platform, to telescoping pole assembly using hardware and instructions provided with C-3090.

C-TCB-9-INST-7-05