- Computers & electronics
- Telecom & navigation
- Mobile phones
- Car kits
- Havis-Shields
- P-REAR-1 W
- Installation instructions
advertisement
INSTALLATION INSTRUCTIONS
P-REAR-1 W/P-MFK-9
REAR PARTITION W/FILLER PANEL MOUNTING KIT
1997-2008 CHEVROLET PASSENGER VANS
Always
!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
TOOLS REQUIRED:
Power drill
Drill bit set
Standard socket set
Ratcheting wrench
COMPONENTS:
QTY DESCRIPTION
1 Partition
1 Mounting Filler Kit
PART #
P-REAR-1
P-MFK-9
P-MFK-9 COMPONENTS:
QTY DESCRIPTION
1
1
Passenger Side Filler Panel
Driver Side Filler Panel
HARDWARE:
QTY DESCRIPTION PART
5 ¼” x 1 ½” Hex Head Lag bolts GSM33062
2 ¼” x 3” Hex Head Lag bolts
INSTALLATION:
GSM33094
• Place and position partition with spring clips facing towards rear of vehicle.
• Bottom frame of partition will be approximately 8 ½” from edge of door Frame.
• Partition will contour trim just inside rear doors of vehicle.
• Drill 3/16” pilot holes into floor of vehicle.
• Loosely bolt partition to vehicle using ¼” x 1 ½” Hex head lag bolts.
• Pre-drill top mounting holes with 3/16” bit. Attach to vehicle using ¼” x 3” Hex head lag bolts.
• Tighten all loose hardware
• Install seat back to its original position
.
P-REAR-1^MFK-9_INST_9-07
Bottom of Rear Partition Frame & Rear Door Frame.
Approx. 8 ½”
¼” x 3” Hex Head Lag Bolts
¼” x 1 ½” Hex Head Lag Bolts
P-REAR-1^MFK-9_INST_9-07
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project