- Computers & electronics
- Cameras & camcorders
- Camera accessories
- Camera mounting accessories
- Havis-Shields
- WGI-F7-H
- User manual
advertisement
▼
Scroll to page 2
INSTALLATION INSTRUCTIONS WGI-F7-H HINGED INTERIOR WINDOW GUARDS 1998-2007 FORD CROWN VIC TOOLS REQUIRED: Safety Goggles Power Drill Drill Bit Set Phillips Screw Driver Open-End Wrench Set Magic Marker Or Pencil HARDWARE: QTY DESCRIPTION PART# 2 2 18 18 10 10 8 Driver & Passenger Side Hinged Window Guards Window Guard Mounting Brackets 10-32 x ½” Phillips Pan Head Machine Screw #10 Flat Washer 10-32 Keps Nuts #10 X ½” Phillips Flat Head Sheet Metal Screw #10 X ½” Phillips Pan Head Sheet Metal Screw WGI-F7-1-H & WGI-F7-6-H WGI-MB-20-00 GSM34097 GSM31003 GSM30026 GSM34150 GSM34169 INSTALLATION: 1. Determine the proper window guard for each window using Window Guard Positioning Chart. . 2. Mount window guards: Note: window guards have holes around perimeter for permanent mounting. These holes are not used with hinge kit. They also come flat in shipping. The guard must be pre-bent (outward) so it fits tight against the door window frame. Do not use holes on side of window guard to mount with the hinge application! 1. 2. 3. 4. 5. Hold window guard with pre-assembled hinge and upper bracket onto window frame. Make sure guard is centered on window. Attach hinge to lower door panel with #10 x ½” Stainless Sheet Metal Screws. Mark upper aluminum bracket location on window frame and remove from window guard. Attach aluminum bracket onto window frame with #10 x ½” Flat Head Sheet Metal Screws. 6. Hinge up window guard and reattach to bracket with 10-32 x ½” Stainless Machine Screws. Note 1: After the 1/8” holes are drilled in metal doorframe, it is helpful to indent the holes inward with a punch. This will enable the mounting screws to grab better. Note 2: The machine screws for upper mounting plate must be removed from the window guard in order to access mounting screws. Placement of upper mount plate is critical in order for machine screws to attach properly. Note 3: Do not over tighten screws. WINDOW GUARD POSITIONING CHART: POSITION #1 POSITION #6 DRIVERS SIDE PASSENGER WINDOW PASSENGER SIDE PASSENGER WINDOW WGI-F7-1-H WGI-F7-6-H WGI-F7-H- INST-9-06
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement