HP rp7410 Safety and Regulatory

Safety and Regulatory Information
HP Integrity rx7620 Server; HP 9000 rp7405, rp7410, and
rp7420 Servers
Fourth Edition
Regulatory Model Number(s): RSVLA-0102 and RSVLA-0102-DC
Manufacturing Part Number : A7027-96034-en
February 2007
© Copyright 2007
Legal Notices
© Copyright 2007 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the express warranty statements
accompanying such products and services. Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.
Revision History
First Edition
Initial release. December, 2003.
Second Edition
Added Taiwan battery warning. July 2004. Part number was A7027-96016.
Third Edition
Added Japanese power cord notice and Disposal of waste equipment notice. April 2005.
Fourth Edition
Added China RoHS statement and perchlorite disposal statement. February 2007
ii
Safety and Regulatory Information
Notational Conventions
1 Safety and Regulatory Information
For your protection, this product has been tested to various national and international regulations and
standards. The scope of this regulatory testing includes electrical/mechanical safety, radio frequency
interference, acoustics, and know hazardous materials.Where applicable, approvals obtained from third-party
test agencies are shown on the product label.
Notational Conventions
WARNING
Warnings highlight procedures or information necessary to avoid injury to
personnel. The warning should tell the reader exactly what will result from what
actions and how to avoid them.
CAUTION
A caution highlights procedures or information necessary to avoid damage to equipment,
damage to software, loss of data, or invalid test results.
NOTE
A note highlights supplemental information.
USA Radio Frequency Interference (FCC Notice)
The Federal Communications Commission (in 47 CFR Part 15 subpart B) has specified that the following
notice be brought to the attention of the users of this product.
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
The user is cautioned that changes or modifications not expressly approved by Hewlett-Packard could result
in the equipment being noncompliant with FCC Class A requirements and void the user’s authority to
operated the equipment.
Chapter 1
1
Safety and Regulatory Information
Japanese Radio Frequency Interference (VCCI)
Japanese Radio Frequency Interference (VCCI)
This equipment is in the Class A category information technology equipment based on the rules of Voluntary
Control Council For Interference by Information Technology Equipment (VCCI). When used in a residential
area, radio interference may be caused. In this case, user may be required to take appropriate corrective
actions.
Korean RFI Statement
Certification Number: E - AAAAA - BB - CCCC
•
E: EMC registration
•
AAAAA: equipment codes (RRL notice, 2000.10.26)
•
BB: certification year
•
CCCC: registration number
Class A Equipment:
Please note that this equipment has been approved for business purpose with regards to electromagnetic
interference, if purchased in error for use in residential area, you may wish to exchange the equipment where
you purchase it.
European Union RFI Statement
This is a Class A product. In a domestic environment this product may cause radio interference in which case
the user may be required to take adequate measures.
Canada RFI Statement
This Class A digital apparatus complies with Canadian ICES-003.
Japanese power cord notice
CAUTION
2
Your computer must use only the power cord that was shipped with the computer. Do not use
this power cord with any other products.
Chapter 1
Safety and Regulatory Information
Australian C-Tick Label
Australian C-Tick Label
Figure 1-1
Australian C-Tick Label
BSMI (Taiwan)
This product is fully compliant to CNS 13438 (CISPR 22: 1993) Class A.
Battery Warning (Taiwan)
The Taiwan EPA requires dry battery manufacturing or importing firms in accordance with Article 15 of the
Waste Disposal Act are required to indicate the recovery marks on the batteries used in sales, giveaway or
promotion. Contact a qualified Taiwanese recycler for proper battery disposal.
Figure 1-2
Taiwan Battery Warning
Acoustics (Germany)
Acoustic Noise (A-weighted Sound Pressure Level LpA) measured at the bystander position, normal
operation,complies with ISO 7779.
Chapter 1
3
Safety and Regulatory Information
IT Power System
IT Power System
To ensure safe operation of this equipment, connect only to an AC power source that contains a protective
earthing (PE) conductor. IP Power Systems do not provide adequate grounding and are not recommended.
TT, TN-C, and TN-C-S Power Systems
These products should not be connected to power systems that switch open the return lead when the return
lead also functions as the protective earth (PE). A separate PE ground wire must be connected to the
equipment at the designated PE terminal tie point.
Installation Conditions
See installation instructions before connecting this equipment to the input supply.
WARNING
The equipment must be provided with a proper AC protective earth (PE) ground
connection.
Network Connected Equipment
The installation must provide a ground connection for the network equipment.
Disposal of waste equipment by users in private household in the
European Union
This symbol on the product or on its packaging indicates that this product must not
be disposed of with your other household waste. Instead, it is your responsibility to
dispose of your waste equipment by handing it over to a designated collection point
for the recycling of waste electrical and electronic equipment. The separate
collection and recycling of your waste equipment at the time of disposal will help to
conserve natural resources and ensure that it is recycled in a manner that protects
human health and the environment. For more information about where you can
drop off your waste equipment for recycling, please contact your local city office,
your household waste disposal service or the shop where you purchased the
product.
4
Chapter 1
Safety and Regulatory Information
Perchlorate Material - Special Handling May Apply
Perchlorate Material - Special Handling May Apply
See http://www.dtsc.ca.gov/hazardouswaste/perchlorate.
This product may include a real-time clock battery or coin cell battery that may contain perchlorate and may
require special handling when recycled or disposed of in California. Refer to the product user documentation
to determine if this product contains batteries, and if so, the battery type(s) that are used.
People’s Republic of China Electronic Industry Standard,
SJ/T11364-2006
Marking for the Control of Pollution Caused by Electronic Information Products
Unless otherwise labeled, this Electronic Information Product Pollution Control Mark applies to HP-branded
Enterprise Storage and Server products.
Additional information about this product may be obtained at the following url:
http://www.hp.com/go/chinarohs
Lithium Battery Caution
WARNING
Observe the correct polarity when changing the lithium battery. There is a danger of
explosion if battery is installed incorrectly.
Replace only with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions and local
disposal requirements.
IMPORTANT Switzerland: Annex 4.10 of SR 814.013 applies to batteries.
Chapter 1
5
Safety and Regulatory Information
Laser Safety
Laser Safety
NOTE
Laser devices installed in this equipment must be certified as Class 1 Laser devices by the
Regulatory Agency recognized by the country where the equipment is installed.
NOTE
If a Fibre Channel I/O card is present, the following laser safety statement applies.
This product contains a laser internal to the Optical Link Module (OLM) for connection to the Fibre
communications port.
In the USA, the OLM is certified as a Class 1 laser product conforming to the requirements contained in the
Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The certification is
indicated by a label on the plastic OLM housing.
Outside the USA, the OLM is certified as a Class 1 laser product conforming to the requirements contained in
IEC 60825-1:1993 and EN 60825-1:1994, including Amendment 11:1996.
NOTE
If a DVD is present, the following laser safety statement applies.
This product contains a laser internal to the Digital Versatile Disc (DVD) housing.
In the USA, the DVD is certified as a Class 1 laser product conforming to the requirements contained in the
Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The certification is
indicated by a label on the DVD housing.
Outside the USA, the DVD is certified as a Class 1 laser product conforming to the requirements contained in
IEC 60825-1:1993+A1 and EN 60825-1:1994+A11.
6
Chapter 1
Safety and Regulatory Information
Laser Safety
Declaration of Conformity
Chapter 1
7
Safety and Regulatory Information
Laser Safety
8
Chapter 1