Barco-ELM G10 - Extron Electronics

IP Link Device Interface
Communication Sheet
Revision: 6/10/2004
This document provides additional assistance with wiring your Extron IP Link enabled product to your device.
Different components may require a different wiring scheme than those listed below.
For complete operating instructions, refer to the user’s manual for the specific Extron IP Link enabled product or
the controlled device manufacturers supplied documentation.
Device specifications:
Test setup:
Type Name:
Manufacturer:
Firmware version:
Model(s):
Extron product:
Firmware version:
GVC version:
Compiler version:
Video Projector
Barco
N/A
ELM G10
IPL T S2
1.04
1.2
1.0.9.0
Driver notes:
Driver has been tested on Barco 6400 DLC
Driver written for Projector Address of 1
Control commands & states:
Power control
On
Off
Input control
Input Slot 1
Input Slot 2
Input Slot 3
Input Slot 4
Input Slot 5
Input Slot 6
Video Mute on
Video Mute off
Power control
On
Off
Power Status
Power On
Power Off
Status Unavailable
Lamp Usage Time
Lamp time (hours)
Input control
Input Slot 1
Input Slot 2
Input Slot 3
Input Slot 4
Input Slot 5
Input Slot 6
Connection Status
Connected
Disconnected
Video Mute
Video Mute on
Video Mute off
Video Mute
Status available:
Page 1 of 2
IP Link Device Interface
Communication Sheet
Cable and adapter requirements for Extron Electronics products:
M/F RS-232 Straight Serial Cable (Part number 26-433-03)
Notes for devices:
Serial communication:
Port Type: RS-232 9-pin D, Female
Baud Rate: 9600
Data Bits: 8 bit
Parity: None
Stop Bits: 1 bit
Flow Control: None
Pin assignments diagram:
General notes:
Projector information obtained from R9001500 BARCO ELM G10 owner’s manual.
Manual : R5976070
Revision : 03
Revision date : 17/10/2000
Revision notes:
Version 2: barc_1_320_2.pke, 5/27/04, updated code, no functional changes.
Version 1: 1/09/03 Created
Page 2 of 2
Revision: 6/10/2004