MicroFlex™

®
MicroFlex
™
Congratulations
You are now the owner of one of the finest
shaving instruments available today...and thank
you for letting Remington play a part in keeping
you well groomed. We’re proud of our products
and the technology that keeps them performing
dependably and efficiently. Your Remington®
MicroFlex™ Shaver is designed to provide you
with a closer, faster more comfortable shave
for years to come.
For best shaving
performance, it is
recommended that you
use your new shaver
daily for two to three
weeks to allow time
for your beard and
skin to adjust.
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical shaver, basic precautions should always be followed including the
following. Read all instructions before using this
shaver.
DANGER
To reduce the risk of electric shock:
■ Do not place or store shaver where it can
fall or be pulled into a tub or sink.
■ Do not place in water or other liquid.
■ Do not reach for a shaver that has fallen
into water, unplug immediately.
■ Except when charging, always unplug this
shaver from the electrical outlet immediately
after using.
■ Unplug this shaver before cleaning.
■ Do not use while bathing or in a shower.
WARNING
To reduce the risk of burns fire, electric shock,
■ Use this shaver only for its intended use as
■
■
■
■
■
■
■
■
■
described in this manual. Do not use attachments not recommended by the manufacturer.
Never operate this shaver if it has a damaged cord or if it is not working properly, if it
has been dropped or damaged, or has been
dropped into water. Return the shaver to
a service center for examination and repair.
Keep the cord away from heated surfaces.
Never drop or insert any object into any
opening.
Do not use outdoors or operate where
aerosol (spray) products are being used
or where oxygen is being administered.
Do not use this shaver with a damaged or
broken cutter or head, as facial injury may
occur.
Always pull on cord plug to unplug from
wall socket. Never pull on electric cord.
Do not plug or unplug shaver when hands
are wet.
Always store your shaver and cord in a
moisture-free area. Make sure your cord is
disconnected from the shaver.
“Household Use Only”.
or injury to persons:
Customer Service
Number
1-800-736-4648
call between 8:30 A.M.4:30 P.M.E.S.T.
■ A shaver should never be left unattended
when plugged in, except when charging your
rechargeable shaver.
■ Close supervision is necessary when this shaver
is used by, on, or near children or invalids.
SAVE THESE
INSTRUCTIONS
Getting Used To Your Shaver
Tips For Use
Cleaning Your Shaver
As with every shaver, your shaver will improve over time. So
allow about three weeks to develop an effective shaving style
and for your skin to adjust to the new shaver. The adaptation
period may take a little longer if your skin is sensitive,if you
are switching from a different way of shaving,or it your alternate between shaving methods.
• Clean your shaver frequently.
• Always keep the protective headquard on the cutter head and keep
the trimmer in the “off” position when the shaver is not in use.
• Before using,make sure that the cutter head assembly is in locked
position.
• Wait at least 15 minutes after getting up before shaving.
• Thoroughly cleanse and dry skin prior to shaving.
• Your R-850 cord/cordless shaver should not be used strictly as
a cord-operated shaver, as continued cord only use will result in
reduction of battery life.
TO ASSURE SMOOTH, EFFICIENT PERFORMANCE,
IT IS IMPORTANT TO CLEAN YOUR SHAVER.
Cleaning your Remington ® MicroFlex ™ Shaver is easy.
To Shave
Push the on/off button locking bar
inward and push upward on the on/off
button to actuate the shaver for shaving.(Locking bar on rechargeable
models only.)
To Trim
To use the Easy-View ™ pop-up trimmer,
simply push the trimmer button up.The
trimmer will pop-up for use.Hold the
shaver as shown in the illustration. To
conserve battery energy (on recharge able shavers only),it is recommended to use the trimmer only
when needed for trimming.When through using,push the
trimmer button downward to lock into the off position.
Trim Sideburns
Simply touch the comb-edge of the
trimmer to the desired line for neat,
clean sideburns.
Trim mustache
Hold shaver at desired trim line for a
quick easy, professional trim.The trimmer can also be used to trim the upper
edge of your moustache.
Shaving Tips and Instructions
For a smoother, more comfortable,moisture free shave,use
a Remington® Pre-Shave Powder Stick.For those who prefer
a liquid,use the non-greasy Remington ® Pre Shave Lotion,
specially formulated with a unique suspended powder and
aloe for extra conditioning and protection.
Operation Instructions
The MicroFlex™ shaver needs no adjustments to the heads or cutters
before you shave.The floating heads will automatically adjust to the
contours of your face.It is not necessary to apply pressure while shaving...let the shaver glide lightly on your skin.This gentle touch makes
shaving easier and helps avoid possible skin irritation.
Simply pull the head assembly out from the shaver by
placing fingers on rib areas of head assembly. Using
the brush supplied,clean the internal part of the head
assembly and the hair pocket area,
where 3 shaver spindles are located.
“At Least Once A Week”.
For more complete cleaning,remove
the cutter retainer assembly from the
head assembly by unscrewing the
center screw knob and clean with
brush.After cleaning put the cutters
back in position.Place the cutter retainer back into
position. Important! Make sure to align the two locating holes in the Cutter Retainer assembly with the
pins in the Head Frame Assembly.(See below).Then
tighten centerscrew knob to lock cutters into place.
Put head assembly onto the shaver
simply by pushing in onto the
shaver. Replace the plastic headguard after cleaning.When removing the headguard or placing it
back onto the shaver, do not apply
pressure to floating cutter surface
as you may damage them. Never
clean the shaver or replace the
cutters while it is plugged into electrical outlet.
Cutter Retainer
Assembly
Head/Frame
Assembly
Center
Screw
Knob
Locating Holes
Locating Pins
Floating
Cutter
Heads
Battery Removal
When is it time to replace your heads
and cutters?
It is very important to replace your heads and cutters when
necessary to insure a close,comfortable shave without irritation. We recommend they be replaced every 12 months.Here
are some signs of head and cutter wear, indicating that
replacement is needed.
Trimmer
Button
Easy-View™
Trimmer
Storage Pouch
Irritation:
As the heads get excessively worn there may be some skin irritation.This would be especially noticed when applying After
Shave lotion.
When the cutters wear you may feel a sense of “pulling”and a
loss of closeness when you shave.This is an indication that it
is time to replace your heads and cutters.
Plastic
Headguard
Brush
Head & Cutter
Assembly
On/Off Button
Locking Bar
(Rechargeable
Models only)
Charging
Indicator
(Green) All Models
except R-835
Low-Battery
Indicator (Red)
Shows When Shaver
Needs Charging
(R-850 Only)
(Corded/Cordless and Cordless Rechargeable
Models Only)
When your rechargeable shaver reaches the end of
its useful life,the batteries must be removed from
the shaver and be recycled or disposed of properly in accordance
with your local and state requirements.
The following procedures should be
followed for battery removal:
• Make sure your shaver is unplugged from any
outlets,so you don’t risk an electrical shock.
• Remove the Head Assembly by gently lifting
the assembly away from the shaver.
• Using a small Phillips head screwdriver, remove
the screws from the upper and lower back
of the shaver.
• Pull or gently pry the the shaver halves apart,
exposing the battery.
• Hold each battery in place and very carefully
slide the clips from the terminals on each
battery.
• Lift or pry the battery out of the shaver.
CAUTION:THESE NICKEL-CADMIUM BATTERIES
MUST BE RECYCLED OR DISPOSED IN ACCORDANCE WITH STATE AND LOCAL REGULATIONS.Do not burn or mutilate,as they may
burst or release toxic materials.Do no shortcircuit,as it may cause burns.
The EPA certified RBRC ® Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery indicates Remington is voluntarily participating in an industry program to collect and recycle these batteries at
the end of their useful life,when taken out of service in the United
States or Canada.The RBRC® program provides a convenient
alternative to placing used Ni-Cd batteries into the trash or the
municipal waste stream,which may be illegal in your area. Please
call 1-800-8-BATTERY™ for information on Ni-Cd battery recycling
and disposal bans/restriction in your area.Remington involvement
in this program is part of our commitment to preserving our environment and conserving our natural resources.”
Remington® Money-Back Offer
MODEL R-850 Corded/Cordless Rechargeable
Operation contains a green charging indicator and
red low-battery indicator to show when shaver
needs recharging. Worldwide voltage 100-240 volts,
A.C., 50-60 Hz
MODEL R-845/R-842 Cordless Rechargeable
Operation with charging indicator, Worldwide
voltage 100-240 volts, A.C., 50-60 Hz
MODEL R-835 Corded operation, single voltage
120 volts, A.C., 60 Hz
All worldwide voltage models have automatic
voltage conversion Shaver will automatically
adjust to any worldwide A.C. voltage between
100 and 240 volts, A.C., 50-60 Hz. Do not
connect to direct current “D.C. Voltage”.
If within 30 days after you have purchased
your Remington® MicroFlex™ Shaver, you
are not satisfied with your shaver and
would like a refund, just return your
shaver, together with the sales receipt,
to the retailer from whom the shaver was
purchased. Remington will reimburse all
retailers who accept shavers within 30
days from date of purchase. If you have
any questions regarding this money-back
guarantee, please call 1-800-736-4648.
To Charge (Models R-842, R-845,R-850)
Full One-Year Warranty
MODEL R-850 has a red low-battery indicator
to show when shaver needs recharging. This also
indicates approximately 5 to 6 minutes of shaving
time left when indicator first comes on. Prior to
using your shaver for the first time, put it on
charge for 24 hours. To charge your shaver:
• Slide the On/Off Button to the “Off” position.
• Connect the cord to the shaver and then to
the electric outlet. The Charging Indicator light
will glow green, indicating your shaver is charging.
• Your shaver cannot be overcharged, so you can
leave it plugged in and charging between shaves.
• Use only the cord supplied with shaver. The
R-842 and R-845 are designed for cordless operation only. Plugging in the cord will not provide the
power to shave. The R-850, on the other hand,
comes with a special feature that allows you to
shave while your shaver is plugged in. Just follow
the steps above to plug in the cord. Turn on the
shaver by pressing on the Locking Bar and sliding
the On/Off Button upward. Your shaver will not
recharge while you are shaving, so after shaving,
leave it plugged in so it can be recharged.
Remington warrants that your product, except as noted below, i s ,o n
date of purchase, free from defect in material and workmanship.
Remington will correct any such defect without charge if you return
the complete product either in person or by mail, postage paid, to a
Remington Company-owned Service Center or Authorized Service
Dealer within one year after date of purchase.
Do not return the product to the retailer from whom the product
was purchased.
This warranty does not cover damage by accident, misuse, abuse or
by affixing an unauthorized accessory or alteration to the product, or
by connection of the product to any but the specific current and voltage indicated in an accompanying instruction booklet, or by any
other conditions beyond our control. REMINGTON SHALL NOT BE
RESPONSIBLE FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL
DAMAGES.
ALL IMPLIED WARRANTIES INCLUDING BUT NOT LIMITED TO IMPLIED
WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE LIMITED IN
DURATION TO ONE YEAR FROM DATE OF ORIGINAL PURCHASE.
This warranty gives you specific legal rights, and you may also have
other rights that vary from state to state. Some states do not allow
the exclusion limitation of incidental or consequential damages or
limitations on how long an implied warranty lasts, so that the above
limitations and exclusions may not apply to you.
No responsibility, obligation, or liability is assumed for the installation
or maintenance of this product.
Warranty service must be performed by a Remington Companyowned Service Center or Authorized Service Dealer and damage or
loss of any kind resulting from servicing by any other person is not
covered under warranty. Enclosed is a listing of Company-owned
Service Centers. Authorized Service Center Dealers may be found in
the yellow pages of your directory. If you wish, you may mail the
product,postpaid, to Remington Products Company, L.L.C.,
60 Main Street, Bridgeport, CT 06604 Attention:Service Department.
U.S. Warranty Service
In the United States, service is provided
by our Company-owned Service Centers
and over 300 Authorized Service Dealers.
The addresses of our Company-owned
Service Centers are enclosed. For the
address of your nearest Authorized Service
Dealer, please consult the Yellow Pages
under “Shaver - Electric - Repair.” If you
wish, you may mail the product, postpaid,
to Remington Products Company, L.L.C.,
60 Main Street, Bridgeport, CT 06604,
Attention: Service Department.
International Warranty Service
Service under the Remington warranty can
be obtained outside the United States by
Remington-Authorized Distributors and
Service Dealers. Please consult your local
telephone directory for the nearest location.
For questions or comments, please write:
Remington Products Company, L.L.C.
P.O. Box 1536,
Horsham, PA 19044-6536
Attention: Consumer Affairs
Questions or Comments: Please call 1-800-736-4648.
Visit us at http:\\www.remington-products.com
Corded Operation
Connect cord to shaver and then to electrical outlet.
Make sure shaver is turned off before plugging
cord into outlet.
P R O D U C T S C O M P A N Y, L . L . C .
60 Main Street Bridgeport, CT 06604
Remington,Easy-View,
Fast-Track and MicroFlex are
trademarks of Remington
Corporation,L.L.C.
© 1998 R.P.C,L.L.C.
7/98
Part No. 12642