Kodak A-61576_EN User's Manual

White Background Accessory for i600/i1800

Series Scanners

A-61576_EN

Part No. 9E4559

October 2006

CAT No. 835 3807

If you are scanning translucent documents, the Kodak

White Background Accessory will reduce black background bleed-through, which produces whiter images. To order this accessory, use catalog number

894 9000.

NOTES:

• When the White Background Accessory is installed, you cannot perform the following functions: automatically detect, automatically detect and straighten or image calibration.

• The following photos may vary slightly depending on your scanner model.

To install the White Background Accessory:

1. Turn the scanner off.

2. Open the pod.

3. Remove the upper black background strip by grasping the green tab and firmly pulling the strip away from the scanner.

Image without

White Background

Accessory

Image with

White Background

Accessory

The White Background Accessory includes two white background strips that replace the black background strips in the scanner. Do not discard the black background strips, as these must be placed back in the scanner for calibration.

4. Take one of the strips included with the White

Background Accessory and put it in place of the black background strip that you removed.

5. Remove the lower black background strip by grasping the green tab and firmly pulling the strip away from the scanner.

6. Take the other strip and put it in place of the black background strip that you removed.

7. Close the pod.

8. Power up the scanner and restart the host computer so the White Background Accessory will be properly recognized by the system.

EASTMAN KODAK COMPANY

Document Imaging

Rochester, NY 14650

Kodak is a trademark .