advertisement
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:LW6U
A0397 Page 1 of 1
INSTALLATION PROCEDURE FOR: LW6CLP; LW6GDP; LW6BKP; LW6CLW; LW6GDW;
LW6BKW; LW7CLP; LW7GDP;LW7BKP; LW7CLW; LW7GDW; LW7BKW — LENS WALL
WASHER CONE TRIM AND LW7U — LENS WALL WASHER LAMP/YOKE ASSEMBLY
6” I.D.
FIG.1 – LAMP/YOKE ASSEMBLY
& LENS WALL WASHER TRIM
7 1/4” I.D.
FIG. 2 – LENS WALL WASHER TRIM
A. INSTALLATION PROCEDURE FOR LAMP/YOKE ASSEMBLY
AND LENS WALL WASHER IN PROSPEC FIXTURES
1. INSTALL LAMP/YOKE ASSEMBLY (Figs. 1 & 3)
Insert LAMP/YOKE ASSEMBLY through aperture opening and push LAMP/YOKE ASSEMBLY up against FRAME SPRINGS until flush with top of FRAME RING. (Fig. 4)
2. HORIZONTAL ANGLE ADJUSTMENT/LOCK (Fig. 4)
Rotate LAMP/YOKE ASSEMBLY so LAMP RING is opposite the WALL (358°). Insert blade of screwdrive into SLOT of TAB and twist into FRAME RING to lock ASSEMBLY in position.
3. REMOVE LAMP/YOKE ASSEMBLY
By pushing TAB outward reverse Step 2 Locking. Insert blade of screwdriver against SPRING and pull down. (Fig. 5)
4. INSTALL LENS WALL WASHER IN PROSPEC FIXTURES
Squeeze the two TORSIONTITE SPRINGS and push them through the SLOTS in the YOKE until trim is flush with ceiling. (Fig. 6)
LAMP
RING
FIG.4
FRAME
SPRING
FIG. 3 – LAMP/YOKE ASSEMBLY
TAB
SLOT
FRAME
RING
WALL
LAMP/YOKE
ASSEMBLY
LAMP
RING
YOKE
SLOT
TORSIONTITE SPRING
FIG.6
LENS WALL WASHER TRIM
WALL
PULL ASSEMBLY DOWN
FIG.5
LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA 02720
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project