Marshall electronic MD-0514 User's Manual

Add to my manuals
2 Pages

advertisement

Marshall electronic MD-0514 User's Manual | Manualzz
7
Composite Video using RGB-HD15-X Cable
Marshall Electronics
Gray and Black are not active when used for composite video or component video signals.
1. Composite Video Signal 1 on RED
2. Composite Video Signal 2 on Green
3. Composite Video Signal 3 on Blue
1910 East Maple Ave.
El Segundo, CA 90245
Tel.: 800-800-6608
Fax: 310-333-0688
www.LCDRacks.com
Email: [email protected]
RED
GREEN
BLUE
MD-0514
Distribution Amplifier
Users Guide
DB HD-15 Female Connector Output
Pin-1 Red Out
Pin-9
Pin-2 Green Out
Pin-10
Pin-3 Blue Out
Pin-11
Pin-4
Pin-12
Pin-5
Pin-13 VS Out
Pin-6 Ground
Pin-14 HS Out
Pin-7 Ground
Pin-15
Pin-8 Ground
DB HD-15 Female Connector Input
Pin-1 Red In
Pin-9
Pin-2 Green In
Pin-10
Pin-3 Blue In
Pin-11
Pin-4
Pin-12
Pin-5
Pin-13 VS In
Pin-6 Ground
Pin-14 HS In
Pin-7 Ground
Pin-15
Pin-8 Ground
6 VDC from
V-PS6-1.2A power supply
Left Pin - Pos
Right Pin- Neg
Product Overview
Features
Electrical Specifications
Mechanical Specifications
8
Warranty
Marshall Electronics warranties to the first consumer, that this MD-0514 Distribution Amplifier will, under normal use, be free from defects in
workmanship and materials, when received in its original container, for a period of one year from the purchase date.
This warranty is extended to the first consumer only and proof of purchase is necessary to honor the warranty. If there is no proof of purchase
provided with a warranty claim, Marshall Electronics reserves the right, not to honor the warranty set forth above. Therefore, labor and parts may be
charged to you.
This warranty does not apply to product exterior and cosmetics. Misuse, abnormal service or handling, improper alterations or modifications in design
or construction, voids this warranty. No sales personnel of the seller, nor any other person is authorized to make any warranties other than those
described above, or to extend the duration of any warranties on behalf of Marshall Electronics, beyond the time period described above.
Due to constant effort to improve products and product features, specifications may change without notice.
Optional Accessories
Operational Setup
Composite Video using RGB-HD15-X cable
Warranty
1
2
3
4
5
6
7
8
1
6
Product Overview
The MD-0514 is a multiformat 1 x 4 distribution amplifier, with signal bandwidth up to 350 MHz. This
module can be used with VGA, SVGA, XGA, UXGA signals. An optional HD15 to 5 BNC cable (RGB5HD15-X) can be used for RGBHV, Y-Pr-Pb, YUV, RGB, and composite signals. Supports screen formats
up to 0 x 1080
2
3
Features
Signal Bandwidth up to 350Mhz
Multiple applications
HD-15 Input Connection self terminating 75Ω
4 HD-15 Output Connections
All connections in rear of module
Includes Power Supply Model V-PS6-1.2A
Install in wall with supplied brackets or use on the desktop
1. Unpack the MD-0514, and accompanying V-PS6-1.2A power supply and physically inspect for any
damage that may have occurred during shipping. Also verify there is a small package with mounting
accessories. Should there be any damage, immediately contact Marshall Electronics at 800-800-6608.
If you are not located within the continental united states call +1 310-333-0606.
2. Install in your desired location. If wall mounting is required, attach the mounting brackets by
removing the Phillips head screws on the sides, closest to the rear of the unit. (See below) Only one
screw per side should be removed. Use the same screw to attach the bracket with the flange facing
away from the side and parallel to the front of the MD-0514 metal case. The flange has two holes.
For desktop use, apply the supplied rubber pads.
Electrical Specifications
Signal Input
Signal Output
Frequency Response
K factor
Signal to Noise
Dynamic gain/phase
Cable length
Power required
4
Operational Setup
HD-15 (VGA, SVGA, XGA, UXGA, RGBHV, YUV, Composite)
4 HD-15
10 to 350 MHz
<1%
>70 db
<1% / <10
250’
6 Volt D.C. supplied from V-PS6-1.2A (included) (1.2Amp Max)
Determine your signal configuration from the table below:
Mechanical Specifications
INPUT SIGNAL
Dimensions
MD-0514 Weight
V-PS6-1.2A Power Supply Weight
7.625”W x 4.125”D x 1.0”H
1.15 lbs (.52kg)
0.20 lbs (0.10kg)
VGA from Computer
VGA from Computer
RGBHV
5
Optional Accessories
Y-Pr-Pb or RGB From camera
Composite Video group
(RGB BNC) (3 Signals)
CABLE
OUTPUT SIGNAL
CABLE
HD-15 Male to Male
(Customer supplied)
HD-15 Male to Male
(Customer supplied)
RGB-5HD15-X (X=length)
(6,10, 15, 20 feet)
RGB-5HD15-X (X=length)
(6,10, 15, 20 feet)
RGB-5HD15-X (X=length)
(6,10, 15, 20 feet)
VGA to Projector
HD-15 Male to Male (Customer supplied)
RGBHV to Projector or Monitor
RGB-5HD15-X (X=length)
(6,10, 15, 20 feet)
RGB-5HD15-X (X=length)
(6,10, 15, 20 feet)
RGB-5HD15-X (X=length)
(6,10, 15, 20 feet)
RGB-5HD15-X (X=length)
(6,10, 15, 20 feet)
RGBHV to Projector or Monitor
Y-Pr-Pb or RGB to monitor
Composite Video group
(RGB BNC) (3 Signals)
3. Connect required cables for signal input and output.
Note that 3 Composite video signals can be applied for distribution on the Red, Green, and Blue BNC
connections of RGB-HD15-X breakout cable. (See Illustration next page)
4. Plug the power supply into the A.C. source
5. Attach power connection to the back of the unit to turn on power.
Verify power on indicator active on the front of the MD-0514
Cable: RGB-5HD15-X
(X = Length in feet 6, 10, 15, 20)
2
V-CB1 Stand
MD-0514 USERS GUIDE
Marshall Electronics
3

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement