MicroBoards Technology 820-00150-01 Quick Reference Guide
Add to my manuals2 Pages
MicroBoards Technology Orbit II, a stand-alone CD copier, offers efficient and reliable duplication of your valuable data. With its user-friendly interface, duplicating your CDs is as simple as loading the master disc, inserting blank discs, and pressing a button. Orbit II's compact design makes it a perfect fit for any workspace, while its advanced features ensure high-quality copies every time. Whether you're a small business owner, a creative professional, or simply someone who wants to preserve precious memories, Orbit II has you covered.
advertisement
Orbit II Stand-Alone CD Copier
Quick Reference Guide
Installation
Instructions
1.
Prepare a workspace for the Orbit II. The dimensions required for the
Orbit II are shown in Fig. A.
2.
Remove the Power Cord, Output
Bin, 3 Input Rods, and Starter Kit from the box. The Starter Kit includes the Documentation CD,
Warranty Card, and Quick
Reference Guides. Position the
Orbit II in the prepared space.
3.
Make sure the switch on the back
Fig. A - Workspace Dimensions of the Orbit II is in the OFF position.
4.
Plug the power cord into the back of the Orbit II, then into the nearest power outlet.
NOTE: It is recommended that you do not use an outlet that is already powering other equipment.
5.
Install the Output Bin on the left side. Extend the bin out to the left until it snaps into position.
6.
Install the Input Rods as shown in Fig. B.
7.
Turn on the Orbit II.
2 Narrow
Input Rods
Wide
Input Rod
Basic Duplication
This is a reference for basic operation and duplication only. Please read the manual for more detailed instructions on the advanced features of the Orbit II.
1.
Load discs into the Input Hopper. The first 5-6 should lay flat, the rest should lean against the short input hopper rod.
See Fig. C.
2.
Press “Yes” when the display reads
“Copy?”
3.
Place the Master Disc in the tray when the reader drive opens. See Fig. D below.
4.
Press the “Yes” key again to start duplication.
5.
When the input hopper is empty, either add more discs and press “Yes” to continue, or press “No” to end the duplication.
6.
Once the duplication has been completed, the reader drive will eject.
Remove the master.
7.
Remove the copies from the Accept bin on the left. Rejected discs, if any, will be to the right of the Orbit II.
Fig. C - Loading Procedure
Fig. D - Reader Drive Ejected
Please save all packing materials from your Orbit II!
Fig. B - Input Rod Positions
Please refer to the Operator’s Manual for information on the advanced duplication features of the Orbit II.
820-00150-01 Rev N
Orbit II Stand-Alone CD Copier
Operating Instructions
Menu Tree
The Yes key accepts the current display question, or underlined character in the
Quantity? display.
The No key declines the current display question, or increments the underlined character in the Quantity? display.
820-00150-01 Rev N
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project