Oregon AW131 User's Manual

LCD SCREEN
TRANSMITTER
1.
Remove the battery compartment cover and insert
the transmitter batteries, taking care to match the
polarities (+ / -).
7.
• Done Alert: 4 beeps followed by “It’s done” when the
meat has reached the target temperature.
• Overcook Alert: The LCD screen will flash and continue
beeping until a button is pressed.
Press any button to silence the alert.
6
BBQ / Oven Meat Thermometer
Grill-Right Wireless and Talking
Model: AW131
When the probe temperature exceeds the
maximum display temperature (300°C / 572°F) the LCD
will flash.
2
3
4
EN
INTRODUCTION
5
Thank you for selecting the Oregon ScientificTM Wireless
Talking BBQ Thermometer. Please keep this manual for
instructions and information you should know about.
OVERVIEW
MAIN UNIT FRONT VIEW
1.
2.
3.
4.
5.
6.
7.
8.
9.
2.
Press RESET and replace the battery compartment
door. The LED indicator will flash to indicate the
transmitter is activated.
TRANSMITTER DATA TRANSMISSION
Place the transmitter within 100 m (330 ft) of the main unit.
The sensor reception icon shows the status.
STRONG
3
4
5
1
•
1. LED indicator
2. RESET
3. POWER:
Activate /
deactivate
transmitter
4. Connector jack
for probe
5. Battery
compartment
3.
2
DESCRIPTION
Beef
1
145 g (5.1 oz)
°C / °F
technician for help.
The following information is not to be used as contact for
support or sales. Please call our customer service number
(listed on our website at www.oregonscientific.com),
c.com or on
the warranty card for this product) for all inquiries instead.
We
Name:
Oregon Scientific, Inc.
Address:
19861 SW 95th Ave.,Tualatin,
Oregon 97062 USA
0°C - 300°C
(32°F - 572°F)
Telephone No.:
Signal frequency
Power
REMOTE UNIT
433MHz
2 x UM-3 AA 1.5 V batteries
declare that the product
86 x 86 x 31 mm
(3.4 x 3.4 x 1.2 in)
Product Name:
Wireless Talking BBQ Thermometer
Manufacturer:
IDT Technology Limited
55 g (1.9 oz)
Address:
Block C, 9/F, Kaiser Estate,
Power
100 m (300 ft) unobstructed
2 x UM-4 AAA 1.5V batteries
ABOUT OREGON SCIENTIFIC
www2.oregonscientific.com/service/support.asp
To start timer:
1. Press START / STOP to begin.
2. Press START / STOP again to pause,
3. Once paused, press and hold START / STOP to reset
to zero.
4. Once a countdown has finished, the unit will beep, to
silence the alert press any button.
Call 1-800-853-8883.
TEMPERATURE UNIT
• Consult the dealer or an experienced radio / TV
Display temperature
range
To set a countdown time:
Use HR and MIN to set the countdown time.
NOTE The countdown timer will count up to 23:59.59
receiver.
• Connect the equipment into an outlet on a circuit
1°C (2°F)
Visit our website (www.oregonscientifi
www.oregonscientific.com)
c.com to learn more
about Oregon Scientific products.
Slide °C / °F to select the temperature unit.
If you’re in the US and would like to contact our Customer
Care department directly, please visit:
Product No.:
1-800-853-8883
AW131
Phase 1,41 Man Yue St., Hung Hom,
Kowloon, Hong Kong
is in conformity with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: 1) This device
may not cause harmful interference. 2) This device must
accept any interference received, including interference
that may cause undesired operation.
OR
For international inquiries, please visit:
www2.oregonscientific.com/about/international.asp.
c.com/about/international.asp
EU-DECLARATION OF CONFORMITY
Hereby, Oregon Scientific, declares that the Wireless
Talking BBQ Thermometer (AW131) is in compliance with
the essential requirements and other relevant provisions of
Directive 1999/5/EC.
A copy of the signed and dated Declaration of Conformity
is available on request via our Oregon Scientific Customer
Service.
VOLUME
Slide HI / LO switch to select the speaker volume level.
2
Veal
indicates when the batteries are low.
3
4
SET LANGUAGE
5
6
The talking language needs to be set when the unit is first
activated, or after changing batteries.
1.
2.
AUTO KEYLOCK
Press and hold POWER to activate the main unit. The
language icons will flash.
Press LANG to toggle to the language desired.
Hamburger
If no button is pressed for 5 seconds auto keylock will
engage. Press any button to unlock.
Pork
BACKLIGHT
Press any button to illuminate the screen for 5 seconds.
Turkey
NOTE The language options are: EN (English), DK
(Danish), FR (French), ES (Spanish) and DE (German).
PRECAUTIONS
•
Chicken
STAND
•
•
Place the unit into the
stand provided and
place on a table or
work surface for easy
viewing and access.
Fish
4.
5.
6.
AW131_M_R8.indd 1
Weight (without
batteries)
Temperature unit
Temperature
Resolution
To set a count-up timer:
If no countdown time is set the timer will act as a count
up timer.
sec.
• Increase the separation between the equipment and
Lamb
10
Belt Clip
RESET
°C / °F: Select temperature unit
Battery compartment
HI / LOW: Select volume level
Battery compartment lever
LANG: Press to select voice prompt language
HR: Select hours for timer
MIN: Select minutes for timer
START / STOP: Start, pause and reset timer
142 x 70 x 39 mm
(5.6 x 2.75 x 1.53 in)
LxWxH
COUNT-UP / COUNTDOWN TIMER
9
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
DESCRIPTION
CAUTION The probe is a sharp metal object, and will
become hot during cooking. Take care when handling.
ICON
8
TYPE
MAIN UNIT
Weight (without
batteries)
Transmission range
Plug the probe connector to the transmitter jack.
Insert tip of the probe into the center of the meat,
taking care not to pierce through it. Do not expose any
part of the probe to open flames.
Press MEAT / UP to navigate and select the desired
meat types. The voice announcement and LCD icon
indicate the meat type.
• Reorient or relocate the receiving antenna.
DECLARATION OF CONFORMITY
SPECIFICATIONS
the main unit or sensor in water.
1.
2.
Insert the batteries as shown, taking care to match the
polarities (+ / -).
the contents of the user manual are subject to change
without notice.
OPERATION
The count-up and countdown timers operate independently
of the temperature sensor.
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
different from that to which the receiver is connected.
NOTE The technical specifications for this product and
LxWxH
2
BATTERIES
Once cooking is finished, remove the probe using an
oven mitt.
Clean the probe with water and a mild detergent.
To clean the main unit and sensor, wipe with a damp
cloth.
•
NOTE Do not clean the probe in a dishwasher or immerse
1. Probe
connector wire
2. Probe tip
GETTING STARTED
•
the transmitter is moved out of range the unit will beep
three times.
MAIN UNIT BACK VIEW
7
NOTE Press and hold MODE to return to automatic
target temperature mode.
AFTER COOKING
3
MEAT / UP: Select meat type / increase target
temperature
POWER: Activate / deactivate unit
COOK / DOWN: Select doneness level / decrease
target temperature
MODE: Select between cooking options
Speaker
5.
6.
Insert the probe into the meat as shown above.
Press and hold MODE to select manual target
temperature mode. When in this mode, the meat icons
will disappear.
Press MEAT / UP and COOK / DOWN to select your
desired temperature.
Your target temperature will appear on the LCD
screen. Begin cooking.
The cooking alerts will sound as described above.
Press any button to silence the alert.
NO SIGNAL
NOTE The LED indicator blinks during transmission. If
5
1
WEAK
3.
4.
indicates the batteries are low.
4
4.
5.
8
1.
2.
Language icons
Doneness level
Low battery indicator
Signal reception icon
Timer icon
Meat types
Target temperature
Current temperature
Timer
2
2.
3.
MANUALLY SET TARGET TEMPERATURE
9
1
1.
7
TRANSMITTER AND PROBE
2
1
•
NOTE
1
USER MANUAL
•
may result in damage to its finish for which Oregon
Scientific will not be responsible. Consult the furniture
manufacturer's care instructions for information.
The contents of this manual may not be reproduced
without the permission of the manufacturer.
Do not dispose old batteries as unsorted municipal
waste. Collection of such waste separately for special
treatment is necessary.
Please note that some units are equipped with a
battery safety strip. Remove the strip from the battery
compartment before first use.
Press COOK / DOWN to select the doneness level
(Rare, Medium Rare, Medium or Well Done). The LCD
and talking announcement indicate selection.
The target temperature appears on the LCD screen.
Begin cooking.
The cooking alerts will sound depending on the
temperature:
• Nearly Done Alert: 2 beeps followed by “It’s nearly done”
when the meat is nearing the target temperature.
•
•
•
•
•
•
Do not subject the unit to excessive force, shock, dust,
temperature or humidity.
Do not cover the ventilation holes with any items such
as newspapers, curtains etc.
Do not immerse the unit in water. If you spill liquid over
it, dry it immediately with a soft, lint-free cloth.
Do not clean the unit with abrasive or corrosive
materials.
Do not tamper with the unit’s internal components.
This invalidates the warranty.
Only use fresh batteries. Do not mix new and old
batteries.
Images shown in this manual may differ from the
actual display.
When disposing of this product, ensure it is collected
separately for special treatment.
Placement of this product on certain types of wood
COUNTRIES RTTE APPROVAL COMPLIED
All EU countries, Switzerland CH
and Norway N
FCC STATEMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including
interference that may cause undesired operation.
WARNING Changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
2/6/07 5:30:00 PM