Radio Shack DIY Color Camera 49-1356 User's Manual

49-1356
• Carefully plan the camera position and cable route.
DIY Color Camera
with Mic
• Select a dust-free location providing a clear view
of the area you want to monitor, and that is not in a
strong light source such as direct sunlight.
• Do not install the camera in a location exposed to
high humidity or rain.
• Select a location for the camera that has an ambient
temperature between -4°F (-20°C) and 122°F (50°C).
Thank you for purchasing your DIY Color Camera with Mic
from RadioShack. Designed for use with the RadioShack
Video Surveillance Switchbox (49-2517), it integrates
seamlessly with color camera observation systems at your
home or workplace. Small and compact, your DIY Color
Camera with Mic enables 1-way communication and for
best resolution, automatically switches to black and white
when light is low.
• Plan the cable’s route so it is not close to power or
telephone lines, transformers, microwave ovens, or
other electrical equipment that could interfere with
the system.
• If you plan to install the camera in a location with
harsh conditions, consult with a professional installer
and consider using a camera cover or housing (not
included).
• Before permanently mounting the camera, first setup
and hold the camera in the desired location and
check its performance on the monitor.
• To illuminate the camera’s viewing area, we
recommend installing a 100-watt incandescent lamp
or a small incandescent flood lamp.
Security Camera
AC Adapter
User’s Guide
Wall Mount Bracket
Use the wall mount bracket to mark
the locations for the two mounting screw
holes.
A/V Cable
Screw (2)
59-Foot Cable
Cable Guide (10)
Drywall Anchor (2)
(Optional) To run the video cable
behind the mounting surface, drill a third
hole at least 14 mm in diameter.
To mount the camera, loosen the
screw from the base of the camera’s neck,
and insert camera onto the arm of the
wall mount bracket. Secure the camera by
tightening the screw.
NOTE:
If mounting to drywall, drill the drywall anchor
holes just large enough to insert the anchors
firmly, then follow the steps above.
Please read this user’s guide before
installing, setting up and using your new product
www.radioshack.com
Position the
camera for the desired
recording view.
Connect the camera
plug into the 59-foot cable
socket then connect the
59-foot cable plug into the
switchbox.
Position the
camera for the desired
recording view.
Connect the AV
cable to the video and
audio jacks on your
monitor, VCR or TV.
Connect the A/V
cable red connector to the
AC adapter barrel plug
and plug it into an AC
outlet.
Connect the barrel
plug of the switchbox AC
adapter to the switchbox
and plug the adapter into
an AC outlet.
Connect one end of your
switchbox A/V cable yellow (video)
and white (audio) connectors to
the video and audio jacks of your
monitor, VCR or TV and the other
ends to your switchbox.
This product is warranted by RadioShack against manufacturing defects in material and
workmanship under normal use for ninety (90) days from the date of purchase from
RadioShack company-owned stores and authorized RadioShack franchisees and dealers.
For complete warranty details and exclusions, check with your local RadioShack store.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102
04/04
Imager .....................CMOS sensor, 250,000 pixel, 330 TV lines, 1/3 inch
Input Voltage ................................................................................ 12 V DC
Lens Angle ........................................................ 90° (viewing angle is 76°)
Audio Frequency Response ...........................................300 Hz to 17KHz
Minimum Illumination ........... 2 lux (without IR LED), 0 lux (with IR LED)
Operating Temperature .................................... -4° to 122°F (-20° to 50°C)
PIR Maximum Detection Range .........................................24 feet at 25°C
PIR Detection Angle (H/V) ............................. Horizontal 70° / Vertical 45°
Dimensions (H x W x D) ..................................1 7/8 x 2 1/16 x 1 11/16 inch
Weight (with wire) ...................................................... 4.8 oz (135+/-10 g)
Specifications are typical; individual units might vary. Specifications
are subject to change and improvement without notice. Actual product
may vary from the product images in this document.
©2005 RadioShack Corporation.
All rights reserved. RadioShack and
RadioShack.com are trademarks
used by RadioShack Corporation.
Connect the camera
plug into the 59-foot cable
socket then connect the
59-foot cable plug into the
A/V cable socket.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult your local RadioShack store or an experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires that you stop using your
battery box. Changes or modifications not expressly approved by RadioShack may
cause interference and void the user’s authority to operate the equipment.
FCC Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
Product
DIY Color Camera
Model
49-1356
Responsible Party
RadioShack Customer Relations
300 RadioShack Circle,
Fort Worth, TX 76102
Phone
817-415-3200
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
49-1356
11A05
Printed in China