Radio Shack Gigaware 16-952 User's Manual

TM
16-952
User’s Guide
7” Digital Photo Frame
Please read this user’s guide before using your new
photo frame.
Package contents
• Photo Frame
• AC Adapter
• User’s Guide
• Quick Start
Features
• 16Mb built-in flash memory stores up to 14 pictures
• Add additional pictures with the 4-in-1 Card Slot
(supports up to 8GB memory card)
1 Power Your Photo Frame
Connect the supplied AC adapter to the DC 5 V jack and
plug in to a standard household outlet.
SD/MMC/XD/MS
memory card slot
Insert a memory card.
DC 5V
Plug in the supplied
AC adapter.
2 Position Your Photo Frame
Keep the frame away from strong magnets, heat
sources, direct sunlight, or excessive dust.
Hanging Slots
Hang your frame vertically or horizontally.
Adjustable Stand
Pull down and rotate to position the frame
vertically or horizontally.
3 Set Your Photo Frame Options
To define frame settings, complete the following steps:
1.Press MENU to enter the main menu.
2.Press PREV, NEXT, UP, or DOWN to navigate to
SETUP and press PLAY/PAUSE/MODE. The setup
menu appears.
3.Use the PREV, NEXT, UP, or DOWN buttons to
navigate to a setting.
4.Use PLAY/PAUSE/MODE and NEXT to select
options. Navigate through the following options using
the PREV, NEXT, UP, or DOWN buttons:
Brightness: –3 to +3
Slide Show Time: 5, 10, or 30 seconds display
time for each photo.
OSD Language: English, French, or Spanish.
Default: Restores all options to factory settings.
Exit Setup Menu: Return to the main menu.
5.Press PLAY/PAUSE/MODE to confirm your settings.
POWER
Turn the frame on or off.
PLAY/PAUSE/MODE
Select functions.
MENU
Access the main menu.
UP/COPY/DELETE
Navigate to, copy, or delete a
photo.
DOWN/ROTATE
Navigate to or rotate a photo.
PREV
Navigate to or view the previous
photo.
NEXT
Navigate to or view the next
photo.
Viewing Photos on Your Frame
Your frame can read memory cards up to 8GB. It
automatically displays saved photos and photos from a
memory card in the SD/MMC/XD/MS slot.
1.Press the POWER button to turn on the frame.
2.Insert a memory card into the labeled slot. The frame
enters Slide Show mode after several seconds.
3.Press PLAY/PAUSE/MODE to enter Browse mode.
The frame displays a single image. Use the PREV
and NEXT buttons to select a photo.
4.Press PLAY/PAUSE/MODE again to enter Thumbnail
mode. Small images of the memory card’s contents
appear. Use the PREV, NEXT, UP, and DOWN
buttons to navigate the pictures.
n Note: The aspect ratio of the screen is 16:9. Photos
with different ratios (for example, 5 × 7 or 4 × 6 photos)
appear with black bars on the sides. Photos shot in
Panoramic mode (with a 16:9 ratio) appear without the
bars. This is a normal function of the frame designed to
retain image quality.
Copying Photos to Your Frame
To copy photos from a memory card to your frame’s
memory:
1.Locate the photo and press UP/COPY/DELETE.
2.Select YES when asked if you want to copy the
photo, then press PLAY/PAUSE/MODE. The frame
can copy up to 14 photos to the frame’s memory.
n Note: You can rotate photos clockwise by pressing
ROTATE repeatedly while the photo is on-screen.
Rotated photos are copied in the rotated position.
Deleting Photos from your Frame
To delete a photo from your frame’s memory:
1.Remove your memory card from your photo frame.
2.Locate the photo and press UP/COPY/DELETE.
3.Select YES when asked if you want to delete the
photo, then press PLAY/PAUSE/MODE. The frame
deletes the photo from the frame’s memory.
n Note: The delete function only deletes photos from
the frame’s memory, not from a memory card.
w Cautions and Warnings
• Do not insert any foreign objects into the frame through
openings; do not spill or spray any liquids on or in the frame
(this may result in a fire or electric shock). Do not place anything heavy on the frame.
• To ensure proper ventilation and proper operation, never
cover or block slots or openings. Keep the frame away from
open flames, such as fires or candles. Do not use the frame
in temperatures higher than 95°F/35°C.
• When cleaning, make sure the frame is unplugged from the
power source. Do not use liquid cleaners or aerosol cleaners. Use a cloth lightly dampened with water for cleaning the
housing only.
• To avoid damaging your photo frame, use the provided
power adapter or an adapter with proper specifications.
Specifications
File format ......................................................................................JPEG
Screen Resolution.................................................................. 480 × 234
Power source............................................................................DC 5V 1A
Compatible RAM.......................................................... SD/MMC/XD/MS
Operating temperature.............................................40 – 98°F (5 – 35°C)
Dimensions (W × H × D)................................................ 10 × 7.6 × 1.5 in
..............................................................................(25.5 × 19.3 × 39 cm)
Specifications are subject to change and improvement without notice.
Actual product may vary from the images found in this document.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Ignition L.P. may cause
interference and void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation
Limited Warranty
Ignition L.P. warrants this product against defects in materials and workmanship
under normal use by the original purchaser for ninety (90) days after the date of
purchase. IGNITION L.P. MAKES NO OTHER EXPRESS WARRANTIES.
This warranty does not cover: (a) damage or failure caused by or attributable to
abuse, misuse, failure to follow instructions, improper installation or maintenance,
alteration, accident, Acts of God (such as floods or lightning), or excess voltage or
current; (b) improper or incorrectly performed repairs by persons who are not a
Ignition L.P. Authorized Service Facility; (c) consumables such as fuses or batteries;
(d) ordinary wear and tear or cosmetic damage; (e) transportation, shipping or
insurance costs; (f) costs of product removal, installation, set-up service, adjustment or reinstallation; and (g) claims by persons other than the original purchaser.
Should a problem occur that is covered by this warranty, take the product and
the sales receipt as proof of purchase date to the place of purchase. Ignition L.P.
will, at its option, unless otherwise provided by law: (a) repair the product without
charge for parts and labor; (b) replace the product with the same or a comparable
product; or (c) refund the purchase price. All replaced parts and products, and
products on which a refund is made, become the property of Ignition L.P. New
or reconditioned parts and products may be used in the performance of warranty
service. Repaired or replaced parts and products are warranted for the remainder
of the original warranty period. You will be charged for repair or replacement of the
product made after the expiration of the warranty period.
IGNITION L.P. EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDITIONS
NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WARRANTIES
THAT MAY BE IMPOSED BY LAW, INCLUDING THE IMPLIED WARRANTY
OF MERCHANTABILITY AND, IF APPLICABLE, THE IMPLIED WARRANTY OF
FITNESS FOR A PARTICULAR PURPOSE, SHALL EXPIRE ON THE EXPIRATION
OF THE STATED WARRANTY PERIOD.
EXCEPT AS DESCRIBED ABOVE, IGNITION L.P. SHALL HAVE NO LIABILITY
OR RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT OR ANY OTHER
PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE
CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE
PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING,
BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE
AND ANY LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT AND ANY
INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF
IGNITION L.P. HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some States do not allow limitations on how long an implied warranty lasts or
the exclusion or limitation of incidental or consequential damages, so the above
limitations or exclusions may not apply to you. This warranty gives you specific
legal rights, and you may also have other rights which vary from State to State. You
may contact Ignition L.P. at: Ignition L.P., 3102 Maple Ave. Suite 450, Dallas, TX 75201 02/09
For product support, call 1-866-315-0426
Protect the environment by recycling used electronics. Go to
E-CyclingCentral.com to find an electronic recycling center near you.
© 2009. Ignition L.P. All rights reserved.
Gigaware is a trademark used by Ignition L.P.
10
Printed
in China
07A09
16-952