Sennheiser Network Router LSP 500 PRO User's Manual

AN IS-1004 v1.0

Application Note

LSP 500 PRO

WLAN Router Reference

To control the LSP 500 PRO via an iPad, a wireless network (WLAN) is required. In order to setup a WLAN for wirelessly controlling the

LSP 500 PRO, you need a router which meets certain requirements. That is why we advise using only tested and recommended routers.

A stable and reliable wireless control of the LSP 500 PRO is not possible with routers which are not compatible.

For more information, please refer to the following sections of the LSP 500 PRO manual “Operating the LSP 500 PRO via a tablet” and

“The operating menu / WLAN”.

Router Specifications

802.11 b/g compatible 2.4GHz WLAN Router, DHCP functionality, UDP multicast support, open or WPA2 protected WLAN

Recommended routers

These two models have been tested thorougly by us and have achieved the best performance regarding range, stability and reliability.

We expressly recommend using one of these two models. Furthermore, it is important to perform the initial configuration recommended by the manufacturer. For further information refer to the instruction manual of the router or the website of the manufacturer.

Brand Model Tested Firmware

Initial configuration with an iPad possible?

Comments

Apple Airport Extreme

A1521 yes, first time OK then

Airport config App required

Buffalo WHR-HP-G300N DD-WRT v24SP2 yes DD-WRTas standard firmware!

Compatible routers

Brand

Allnet

Apple

Model

ALL02761

Airport Express

A1264

Tested Firmware

1.0 Release 04

Apple

Asus

D-Link

Linksys

Netgear

Airport Express

A1392

RT-N13U

DIR-826L

E1200

WNDR3700v4

2.0.2.0

1.01

2.0.04

1.0.1.32

Initial configuration with an iPad possible?

yes

Comments slow recognition of LSPs yes, first time OK then

Airport config App required yes, first time OK then

Airport config App required old plug model new desk model

Popup on iPad - connection on WAN-

Port needed no yes (manual configuration)

Multicasting must be enabled over menu (Network->Advanced-

>Advanced Network->Enable IPv4

Multicasting) yes iPad shows hotspot screen on first connect but then works

Sennheiser electronic GmbH & Co. KG

Am Labor 1, 30900 Wedemark, Germany www.sennheiser.com

AN IS-1004 v1.0 | 1/1