SPT SF-613 User's Manual

www.sylvane.com 1-800-934-9194
Instruction Manual
Evaporative Swamp Cooler
It is important that you read these
instructions thoroughly before using
your new air cooler and we strongly
recommend that you keep them in a
safe place for future reference.
Model No. SF-613
www.sylvane.com 1-800-934-9194
CONTENTS
TABLE OF CONTENTS ---------------------------------------------------- 1
A. PRODUCT INTRODUCTION --------------------------------------- 2
B. TECHNICAL PARAMETER ----------------------------------------- 2
C. CONTROL PANEL, LCD & CONSTRUCTION DIAGRAM --- 3
D. SELECTION OF FUNCTIONS -------------------------------- 4 ~ 5
E. CARE AND MAINTENANCE --------------------------------------- 5
F. CAUTIONS -------------------------------------------------------------- 6
G. PACKING LIST --------------------------------------------------------- 8
DEFECTIVE NOTICE ------------------------------------------------- 8
WARRANTY ------------------------------------------------------------- 9
1
www.sylvane.com 1-800-934-9194
A. PRODUCT INTRODUCTION
SF-613 Air cooler is our latest design with microcomputer control system. It has
device for storing water and ice cubes. It can lower surrounding temperature, freshen
the air with equipped anion, humidify the air through the principle of water
evaporation and melting ice. LCD panel makes it luxurious and easy to use. Also
equipped with double-layered, filtration mesh water curtain to remove odor and dust.
This unit will provide you a comfortable and healthy environment.
BRIEF INTRODUCTION OF FEATURES
1.
2.
3.
4.
5.
6.
7.
8.
9.
High-grade computer-control system with LCD panels.
Remote control.
Functions include: cool fan, humidifier, air filtration, and ionizer.
Energy-saving and effective, input power of cooler is 60W.
0.5 to 7.5-hours timer control.
3 fan speeds: High – Medium – Low.
Water tank for cooler air output.
Activated carbon removes odor.
Filter to remove harmful tiny substances, such as dust and pollen.
B. TECHNICAL PARAMETER
Main technical parameter
2
Rating voltage frequency
120V / 60Hz
Input power
60W
Water consumption
0.5-0.6L/h
Max air volume
20m³/min
Fan Speeds
7.4 m/s
N. W.
19.9 lbs
Dimension (L x W x H)
14.5 x 11.5 x 31.75 in.
www.sylvane.com 1-800-934-9194
C. CONTROL PANEL, LCD DISPLAY AND CONSTRUCTION DIAGRAM
1. Control panel and functions (Same with remote controller)
CONTROL PANEL
TIMER
LCD DISPLAY
COOL
SPEED
Sleep Mode Indicator
SWING
Timer Indicator
MODE
POWER
POWER
Cool Indicator
Fan Speed Indicator
Auto Swing Indicator
2. Construction diagram.
Control buttons
LCD
Outlet of
air flow
Handle of
front door
Door
Strainer
Filter on
rear cover
water leel
glass
Water level window
Caster
Roller
3
www.sylvane.com 1-800-934-9194
D. SELECTION OF FUNCTIONS
1.
ON/OFF: Turns unit ON or OFF
Press once to turn ON. Following indicator lights will illuminate: POWER,
IONIZER, and SPEED. Unit operates in default High fan speed. LCD
panel will display rotating fan at High speed.
Press again to turn OFF.
IONIZER turns on automatically when unit is powered on.
2. FLOW: Horizontal swing of vertical louvers.
Press once to engage auto swing of louvers. FLOW indicator light will
illuminate and LCD panel will display auto swing indicator.
Press again for fixed air direction.
To directing vertical airflow, adjust the horizontal louvers manually.
3. Speed: Selects fan speed.
Press to select desired fan speed: High – Medium – Low, in turn. LCD
panel will display the corresponding air speed.
4. Sleep: Unit operates according to preset computer program, alternating
between different fan speeds.
Press to engage in Sleep Mode. SLEEP indicator will illuminate and LCD
panel displays the sleep (moon) indicator.
To return to regular fan mode, press either SLEEP or SPEED button.
5. Cool: For cool air / humidify function.
Press once to start the evaporative cooling function. COOL indicator light
will illuminate and LCD panel displays the cool (snowflake) indicator.
Press again to stop function and operate in regular fan mode.
Make sure water is added before turning on this function. Unit cycles the
water to blow cool, humidified air.
Add ice to the water tank for added cooling.
6. Timer: Sets timer-off in increment of 0.5 hours.
Timer can be set between 0.5 to 7.5 hours.
TIMER indicator will illuminate and LCD panel will display the set time.
To remove timer and operate unit continuously, press button repeatedly
until indicator light and display goes off.
7. Oxygen Bar with Negative ion.
Fan releases negative ions into the air.
Operates automatically when unit is turned on.
NOTE: Water must be added to the water tank before using the COOL function.
4
www.sylvane.com 1-800-934-9194
Open the front door by the pulling gently on the handle.
Add water to the tank. Do not overfill.
For added cooling, add ice to the tank. (Fig. 1)
Power supply should be disconnected before filling to prevent electrical parts
from damage.
Fig 1
E. CARE AND MAINTENANCE
Always power OFF and unplug the unit before cleaning and maintenance.
Clean the housing with a damp cloth. Never spray water directly onto the
housing or control panel/LCD or use harsh chemicals.
After long time operation, the Filter and Water Curtain becomes clogged with
dust and dirt, which will greatly affect the unit’s performance. Sometimes
mold and mildew may also occur, due to lack of water changes. It is
recommended to clean the filter and water curtain once every two weeks.
Filter Handles
Water Tube
(Fig 2)
5
(Fig3)
(Fig 4)
www.sylvane.com 1-800-934-9194
Cleaning the Dust Filter
1. Disconnect the power supply.
2. Push down on the two handles of the filter and pull outwards. (Fig 2)
3. Clean under lukewarm water and mild detergent.
4. Make sure filter is completely dry before operating unit.
Cleaning the Water Curtain
1. Disconnect the power supply.
2. Remove the 3 screws located on the back frame: one in each top corner and
one at bottom center. Do not remove back panel yet.
3. Panel is connected to the unit by a water tube, gently remove end of tube
that is connected to the water pump. (Fig. 3) Remove back panel.
4. Remove water curtain by first removing the bottom rod – push in gently.
Then remove from top rod by separating the Velcro attachment.
5. Wash water curtain in a mild detergent and warm water solution, then rinse
in clean water. (Fig. 4)
6. Replace water curtain; make sure tube is firmly connected to the pump.
Storage
If you plan not to use the unit for a long period of time, drain the water tank and
wipe clean. Clean the filter and water curtain. Operate the unit in normal fan
mode for approximately 30~60 minutes on a sunny day. This will dry the interior
and prevent mold from growing. It is recommended to pack the unit in its original
box and store in a dry, cool place
F.
CAUTIONS
(Fig. 5)
(Fig. 6)
(Fig. 7)
1. Use normal supply of 120V / 60Hz. Plug into dedicated socket with minimum
rating current of 3A.
6
www.sylvane.com 1-800-934-9194
2. After filling with water, do not tilt unit and avoid moving unit – which may
cause water to overflow the sides of the tank and leak. If unit needs to be
moved a little, push on the side gently. (Fig. 5)
3. Never turn the unit on its sides. (Fig. 6)
4. Do not place any heavy objects on top of the Air Cooler. The air outlet must
not be obstructed. (Fig. 7)
Fig. 8
Fig. 9
Fig. 10
Fig 11
5. Keep a minimum space of 6 inches around the unit. (Fig. 8)
6. Suitable ambient temperature range is 68~104°F. The body of this Air Cooler
should not be placed in area with extremely high or low temperature. When
ambient temperature is high, change water frequently to prevent mildew and
mold growth. (Fig. 9)
7. Never wet the unit or spray water onto the control panel or LCD. (Fig. 10)
8. Do not use any corrosive cleaner or solvent. (Fig. 11)
9. If using unit as a humidifier during cold weathers (below 32°F), be sure to
empty and dry up the water tank after use to prevent water freezing. After
emptying water from the drain, use a towel to suck up remaining water.
10.
11.
12.
13.
14.
Empty the water tank before moving the Air Cooler.
Unplug power source when not in use.
Do not use the COOL function if unit is used in a damp and closed space.
Do not place fingers or insert foreign objects into the louver during operation.
Do not operate unit with a damage power cord or plug. Contact Sunpentown,
do not attempt to repair on your own.
15. Basic precautions should be taken when operating unit near young children.
16. When operating in COOL mode, pay attention to water level and add water
when water level is less than 1/3 full. Do not operate COOL mode on an
empty tank, as this may cause water pump to malfunction.
7
www.sylvane.com 1-800-934-9194
G. PACKING LIST
No.
NAME
QUANTITY
1
Air Cooler
1
2
Remote Controller
1
3
Instructions Manual
1
DEFECTIVE NOTICE
If this product is defective or not working properly
Please DO NOT return to your retail store
Please contact us directly with any Service or Technical Assistance
Contact us toll free at:
1-800-330-0388
8
www.sylvane.com 1-800-934-9194
Your Guarantee
If this product is found to be faulty as a result of faulty materials or workmanship
within one year from date of purchase, it will be repaired free of charge.
This guarantee is subject to the following terms:
Sunpentown must be notified of the fault.
Proof of purchase must be presented to Sunpentown’s nominated
representative.
The warranty will be void if the product if modified, misused or repaired by an
unauthorized person.
The warranty after repair will not be extended beyond the original one-year
period.
All replacement parts will be new or reconditioned.
Parts, which are replaced, become the property of Sunpentown.
The warranty applies for the use of the product in the USA only.
What is NOT COVERED:
Warranty does not include freight charges.
Incidental or consequential damage caused by possible defects with this
product.
Damage to product caused by improper power supply voltage, accident, fire,
floods or acts of nature.
Failure of product resulting from unauthorized modifications to the product.
Improper installation or failure to perform the necessary maintenance.
This GUARANTEE is in addition to your Statutory Rights
9