Splash Guards Installation Instructions

INSTALLATION
INSTRUCTIONS
PARTS LIST
Accessory
Application
SPLASH GUARDS
2010 TL
Publications No.
BII 42539
Issue Date
AUG 2009
2
Rear brackets
Left front splash guard
TOOLS AND SUPPLIES REQUIRED
Right front splash guard
Stubby Phillips screwdriver
90° Phillips screwdriver
INSTALLATION
NOTE:
Left rear splash guard
• Splash guards cannot be installed with side and rear
under spoilers.
• These installation instructions show the left splash
guards being installed. The same procedure applies to
installing the right splash guards.
• Clean and wax the areas to be covered with a highquality paste wax.
Right rear splash guard
Installing the Front Splash Guards
1.
Turn the steering wheel fully counterclockwise.
CLIP
(Discard.)
LEFT FRONT INNER FENDER
Left rear bracket
Right rear bracket
8
4 SELF-TAPPING
SCREWS (Reuse.)
Self-tapping screws
FRONT
2
Clips
832708BR
2.
© 2009 American Honda Motor Co., Inc. – All Rights Reserved.
BII 42539 (0908)
Remove the four self-tapping screws and one clip
from the left front inner fender.
08P00-TK4-2000-91
1 of 3
3.
Install the left front splash guard using four selftapping screws. Do not tighten the self-tapping
screws yet.
7.
Install the left rear bracket on the left rear inner
fender with two self-tapping screws.
The oval hole
goes up.
LEFT FRONT INNER FENDER
LEFT REAR
INNER FENDER
LEFT REAR
BRACKET
NEW CLIP
2
2 SELF-TAPPING
SCREWS (reused)
LEFT FRONT
SPLASH GUARD
4
1
3
4 SELF-TAPPING
SCREWS (reused)
8.
832709BR
4.
While holding the left front splash guard against the
left front inner fender, tighten the self-tapping screws
in the order shown. Install the new clip.
5.
Turn the steering wheel all the way clockwise, and
repeat steps 2 thru 4 to install the right front splash
guard.
832802BR
Secure the left rear splash guard on the left rear
inner fender with two new self-tapping screws and
one screw which is reused. Do not tighten the selftapping screws yet.
LEFT REAR
INNER FENDER
Installing the Rear Splash Guards
6.
Remove the three self-tapping screws from the left
rear inner fender.
SELFTAPPING
SCREW
(reused)
LEFT REAR INNER FENDER
3
2
2 NEW
SELFTAPPING
SCREWS
3 SELF-TAPPING
SCREWS (Reuse.)
9.
FRONT
832801BR
2 of 3
BII 42539 (0908)
1
LEFT REAR
SPLASH GUARD
832804CR
While holding the left rear splash guard against the
left rear bumper, tighten the self-tapping screws in
the order shown.
© 2009 American Honda Motor Co., Inc. – All Rights Reserved.
10. Install the rear bracket to the left rear splash guard
and rear bumper with two new self-tapping screws.
REAR BUMPER
REAR BRACKET
LEFT REAR
SPLASH GUARD
2 NEW
SELF-TAPPING
SCREWS
FRONT
861203AR
11. Repeat steps 6 thru 10 to install the right rear splash
guard.
© 2009 American Honda Motor Co., Inc. – All Rights Reserved.
BII 42539 (0908)
3 of 3