Zadro SUN365 User's Manual

Caution:
Do not stare directly at the Sunlight 365.
Users with eye problems, eye injury, laser corrective eye surgery
or any other eye related conditions - you are advised to consult
youropthalmologist or health care provider beforeusing the
Sunlight 365.
This product is not listed as a medical device.
If you feel uncomfortable after using the Sunlight 365, discontinue use immediately & consult your doctor.
If the product display stops functioning replace the CR2032
battery and re-plug the adapter.
Electric Specifications:
Voltage: 6V DC
Amperes: 800mA
Operating temp: 20°F - 140°F
Light Frequency: 470nm
What is Sunlight 365?
Sunlight 365 is a light that mimics natural
sunlight. It is designed specifically to
produce certain wavelengths of light in order
to give user the effect of artificial sunlight.
Operating Instructions
for Sunlight 365
To turn on the SUN365 press the “Power”
button. The LCD display will show the “Time”
To turn the SUN365 off, press the “Power”
button for approximately two to three
seconds. The LCD display will go blank.
To have just the LED lights on without
programming, turn the SUN365 “ON” then
press the “intensity” button.
To turn off the LED light, press the “Timer”
button.
On/Off
Timer
Light regulates our lives. We wake up with
the light and go to sleep when it is dark.
Intensity
Program
During winter months when there is not a lot
of natural sunlight or when it’s raining or
snowing, you might be affected by not being
as active and feel the “blues”. A bright light in
a sunlight frequency can help as your brain
perceives it as natural sunlight.
Up
Down
• It is safe as there are no UV rays.
• There are no chemicals.
• It is portable so you can travel with this unit.
Plug adapter into SUN365
and then plug adapter into
power outlet.
Sunlight 365 Features:
• 10,000 LUX of Light
• 35 Blue LED’s
• Adjustable Light Intensity 10% - 100%
• Countdown Timer
• Compact for Travel
• Programmable
• Desktop Clock
• LCD Backlight
• FREE POUCH
• Power Adapter
Recommended usage:
To Replace The Battery:
• Use as early as possible in the morning.
Note: The battery is for the clock function.
1. Slide open the battery cover.
2. Install the battery; make sure
the polarity matches the
markings in the compartment.
3. Use CR2032 x1 button cell
battery (included).
• Daily use: 30-60 minutes.
• Place at an arms length away.
Do not let this light treatment interrupt
your normal activities: eating breakfast,
reading newspapers, watching television,
etc.
Glance at the light occasionally during
each session.
Program:
IMPORTANT!
Keep the instructions. Do not discard.
Used batteries should be removed to
avoid damage.
Slide To Open
1. Turn on the SUN365.
2. Press the program button, located on the lower
center of the keypad.
3. The LCD will show the timer time, the clock time,
the program letter “A”, “B” or “C” and the LED
intensity. As shown here:
4.
5.
6.
7.
8.
9.
Press the program button again to set the hour.
Press the clock/timer button to set the minutes.
Press the “program” button again.
A symbol of a bell will flash on the LCD display.
Press the clock button to set the alarm hour.
Press the clock button again to set the alarm
minutes.
10. To set the LED program, press the program
button.
11. The timer time program and intensity will be
displayed on the LCD display.
12. By using the “UP” & “DOWN” buttons, choose
program “A”, “B” or “C”.
13. Press the timer button and using the “UP” &
“DOWN” buttons set the LED timer, 15, 30, 45 or
60 minutes.
14. Press the “Intensity” button to set the
brightness of the LED’s from 10% thru 100%
15. Press and hold the program button for
approximately 3 seconds.
16. The clock and function symbols will appear on
the LCD.
17. There will be a delay of 10 seconds, and then
the SUN365 will run your set program.
Keep button cell battery out of reach of
children. Do not use adapters other than
those supplied with the product. Dispose of
batteries according to the local laws and
regulations of your region. Some batteries
may be recycled, and may be accepted for
disposal at your local recycling center. If you
are not able to identify the applicable rules in
your area, please check the instructions of the
battery manufacturer.