Mount Assembly Guide

MOUNT ASSEMBLY
GUIDE
PATENT PENDING
This product is protected under US and Global Patent and Trade Laws
3 Dec 2011
1
75cm Dish
LNB Arm
LNB
28 x 38 x 6
15 Lbs.
Mount
Cables
Hardware
Roof Connector Cover
Clam Shell
14 x 16 x 18
LNB Arm
75cm
40 Lbs.
LNB
2
One of two combina*ons
SHAW Direct
DirecTV SWM
3 Holes
Two Holes
vGPS (Side Car)
SHAW Direct
DirecTV SWM
3
Contents of the Mount Box
Remove side packing
4
Review Contents
Mount
Controller
Cables and Power Supply
LNB Arm Skid Plate
Hardware and Roof Connector Housing Kit
Elevate the Mount for ease of assembly by using the
Controller, Control cable and Power supply (pin 6
“UP” on the controller)
5
Good angle for installing the dish
Locate the Installa*on
Hardware Kit
6
1 ea. 12 Pin Green Connector
2 ea. Black Cable Ties
1 ea. Roof connector Housing/base with 4 screws
1 ea. Clam Shell
6 ea. Dish a,achment screws
2 ea. Washers
7
A>er feeding the coax
cables through the hole
in the dish a?ach the
dish using 2 of the 6
screws and 2 washers.
Do not *ghten at this
*me.
A?ach the LNB
Arm using the
remaining 4
screw and *ghten all 6 dish
screws. The finished assembly
will look like this.
8
LNB Arm Stow and vGPS Brackets
DirecTV SWM
Slide in this direc*on
SHAW Direct
Slide in this direc*on
9
Showing correct installa*on of the
vGPS unit on the Stow Bracket
Alignment notch
Screws a?aching the
DirecTV SWM LNB to
the LNB Arm
DirecTV SWM LNB
installa*on
10
11
The Moun*ng Feet are shipped in the retracted posi*on.
Depending upon the structure of the roof they may be installed in this posi*on.
Or may be rotated outward to provide
addi*onal roof coverage.
12
Fully deployed Moun*ng Feet
Roof Connector Housing
13
LNB Arm Skid Plate
LNB Arm Skid Plate protects the roof from LNB Arm stowing. It is mounted 7 inches from the leading edge of the
mount.
Just as the LNB Arm touched down
14
Mount fully stowed
15
16
This pictorial was created to be a guide in the assembly of the RF Mogul Mount. It was not intended to give you every detail.
Only you can provide the common sense to do it properly. Do not take any shortcuts which may cause product failure in the
future. This mount has been designed to provide years of reliable service when installed and used properly. If you have any
ques7ons concerning the installa7on and opera7on of your system you may call our Customer Support line at 801-509-9755
for assistance.
Enjoy what this system can do for you,
The Staff at RF Mogul
RF Mogul
3604 Via Terra
Salt Lake City, UT 84115
www.rfmogul.com
17