Xcluder Fill Fabric Installation Instructions

Xcluder Fill Fabric is designed to stop gnawing and burrowing pests from entering your house, apartment, mobile home or building in a safe and environmentally responsive way. For preventing pest intrusion, permanent solution for rodent control!

Xcluder is superior and a

750 West Lake Cook Road

Buffalo Grove, IL. 60089

Phone: (847) 495-4730 www.buyxcluder.com

U.S. Patent No. 6,919,117

Xcluder is made from coarse stainless steel wool, which has sharp edges. ALWAYS WEAR GLOVES AND USE CARE IN HANDLING AND CUTTING. AS

ALWAYS WITH ANY HOME IMPROVEMENT PROJECT, WHEN WORKING OVERHEAD USE SAFETY GLASSES TO PREVENT LOOSE FIBERS FROM

GETTING INTO THE EYES.

To contain loose fibers, always cut

Xcluder over a trash receptacle. CUT

XCLUDER

BELOW EYE LEVEL.

Do not use

Do not use

Xcluder on surfaces that may exceed 270

Xcluder o F. in electrical enclosures or receptacles.

TOOLS NEEDED

STEP 1: IDENTIFY IT

Identify the gaps and spaces where rodents can enter or where there is evidence rodents have entered.

STEP 2: MEASURE IT

Measure the width and depth of the space using a tape measure as pictured or any other measuring device.

Xcluder Document # XCLINSTBULK Ver: 1.00 05.2013

Use for part #’s: 162743, 162746

STEP 3: CUT IT

Use sturdy, sharp scissors to cut a piece of Xcluder that is slightly larger than the opening (about

1½x to 2x the width of the opening is usually sufficient).

STEP 4: FIT IT

Firmly place the Xcluder into the opening. Be sure to fill the entire opening, leaving no gaps or spaces.

STEP 5: PACK IT

Using the blunt side of a screwdriver, push the material into the opening so that it is flush to, or slightly below the surface of the opening. Properly installed,

Xcluder will expand to form a better seal shortly after installation.