Muskoka MFB28-2 Technical data

MODEL NO. MFB28-2
INSTRUCTIONS FOR USE
Natural flame effect
Constant temperature
Ventilator control switch
Energy-saving
Easy to use
Elegant design
Plug connected
120V~ 60Hz 1400W
第 1 页
IMPORTANT INSTRUCTIONS
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. If provided, use handles when moving this heater. Keep
combustible materials, such as furniture, pillows, bedding, papers, clothes,
and curtains at least three feet (0.9m) from the front of the heater and keep
them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or
invalids and whenever the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanical
adjustment, or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar
indoor locations. Never locate heater where it may fall into a bath but or
other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners,
or the like. Arrange cord away from traffic area and where it will not tripped
over.
9. To disconnect heater, turn controls to off, then remove plug from outlet.
10. Connect to properly grounded outlets only. (This item may be omitted if the
heater is not provided with a grounding type attachment plug.)
11. Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
12. To prevent a possible fire, do not block air intakes or exhaust in any manner.
Do not use on be soft surfaces, like a bed, where openings may become
blocked.
13. A heater has hot and arcing or sparking parts inside. Do not use it in areas
where gasoline, paint, or flammable liquids are used or stored.
14. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury
to persons.
15. Avoid the use of an extension cord because the extension cord may overheat
第 2 页
and cause a risk of fire.
16. This heater may include an audible (a visual) alarm to warm that parts of the
heater are getting excessively hot, if the alarm sounds (flashes), immediately
turn the heater off and inspect for any objects on or adjacent to the heater
that may cause high temperatures. DO NOT OPERATE THE HEATER
WITH THE ALARM SOUNDING (FLASHING)
17. SAVE THESE INSTRUCTIONS
How to operate:
Special characteristics of this heater
a. The smouldering glow of the flames can hardly be distinguished from that of
a real fireplace. This heater is deal for use outside the cold season, when the
central heating is switched off.
b. Produces the effect of a hot current of air.
MANUAL CONTROLS:
The function controls located behind the bottom access panel
Before using remote control or touch pad operation, please confirm the master
switch on “ON” position.
You have the following controls
第 3 页
Unpacking and installing the appliance
Open the packaging carefully and remove the appliance. Keep the original
packaging for future transport.
Keep the front of the appliance through which the heat is radiated at least one
meter away from furniture, curtains and other flammable objects at all times.
Ensure there is a grounded socket nearby. ( back of the appliance).
Never use an extension lead. The mains cable must remain at the back of the
appliance and must not be in contact with any hot elements.
Safety instructions
Only use the appliance in accordance with the instructions in this manual! It
第 4 页
cannot be used for any other purpose. Any damage due to inappropriate
operation, wrongful use or not observing the safety instructions is not covered by
the guarantee.
Please operate the heater after inserting it into the mantle.
Never operate the appliance when the appliance itself or the mains cable show
any signs of damage.
Be responsible when handling the packing material.
Warning: plastic wrapping may be lethal to children.
Do not place the appliance below a socket.
Never operate the heater on a program switch, timer switch or any other
appliance for automatic operation.
The heater is only suitable for indoor use.
Never use the appliance near the bath, shower or a swimming pool.
Never place flammable objects or clothing on top of the heater.
Do not cover the heater.
Never leave children unattended near the appliance.
In case of malfunction, disconnect the plug immediately.
When not in use for a considerable amount of time, unplug the appliance.
Repairs such as replacing a bulb should only be performed by an approved
electrotechnician.
Components should only be serviced by an approved electrotechnician.
Cleaning the exterior of the appliance
Before cleaning the appliance, disconnect it from the socket and leave to cool off.
You can clean the exterior of the heater with a soft, damp cloth. Do not use
cleaning or polishing products.
Manufacture’s guarantee
There is an ex fabrica guarantee of one year. During this period, faulty
components will be repaired or replaced free of charge, if the fault is due to a
manufacturing defect.
In this case, consult the retailer where you have purchased the appliance.
(Below some more instructions for the approved electrotechnician who carries
out maintenance or repairs to your heater):
第 5 页
Instructions for the approved electrotechnician
The appliance comes with the following light bulbs:
two 40W light bulbs(max. 40W)
Changing the bulbs
Warning: unplug first! The plug must be removed from the socket-outlet before
changing
1. open the front access panel
2. screws out the two small panels(there are two crews each panel)
第 6 页
3. change the bulbs
CAUTION: sharp edges!
You can now replace faulty bulbs by identical ones with the same wattage.
For assembly, proceed in reverse order.
1. After installation, the power plug should be accessible.
2. if the power cord is damaged. It must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
3. the heater must be located immediately below a socket.
4. the appliance is not intended for use by young children or infirm persons.
Young children should be supervised to ensure that they do not play with
the appliance.
5. do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
6. in order to avoid overheating, do not cover the heater.
USER INSTRUCTIONS
1. Instructions and cautionary statements for cleaning, user-maintenance,
operations recommended by the manufacturer, such as lubrication or
nonlubrication, and a warning to the user that any other serving should be
performed by an authorized service representative.
2. any heater employing a manually reset control shall be provided with
instructions to the user regarding its operation.
3. specific instructions for the proper method of cord storage, total heater
storage, and the like when the heater is not in use.
第 7 页
Grounding instructions
This heater is for use on 120 volts. The cord has a plug as shown in Figure A.
Figure A
Technical data:
Mains voltage: 120V
Mains frequency: 60Hz
Nominal charge: max. 1400W
ELECTRICAL DIAGRAM
第 8 页
第 9 页