none NUC-3-21-WH Installation Guide

LED Under Cabinet V3
INSTALLATION INSTRUCTIONS
NUC-3
CAUTION
1. Read all instructions carefully for safe operation and installation
2.
3. All wiring must be in accordance with national and local electrical codes. Installation work and electrical
4. Do not install over a heat source or directly over water.
6
1
Carefully unpack the Under Cabinet and hardware from its packaging.
Inspect product for defects due to shipping (refer to Fig. A).
2
Insert connector (1) in the desired knockout (2) in housing.
3
Open the top cover of the housing (3). Install the green wire with the
close-loop ring over the connector barrel (1) and secure to housing by
using the lock nut (4) provided.
4
Insert supply wires (not provided) through connector (1) and secure
with the two screws (6) pre-installed on the connector (1). Attach black
FIGURE A
1
4
2
3
3
5
nuts (provided) to splice connections.
5
Mount housing to desired surface with the two mounting screws (5)
provided (refer to Fig. C).
FIGURE B
Open the top cover and securely fasten the mounting screw.
6
Restore power and check installation
Note: Requires 120VAC/60Hz power supply for proper operation.
FIGURE C
5
NICOR, Inc. rev10242014
7
7