JESCO Lighting KIT-SD122-A Installation Guide

INSTALLATION INSTRUCTIONS • ORIONIS SERIES
KIT-SD122 – ORIONIS SURFACE MOUNT
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
When installing or using this product, basic safety precautions should always be followed including the following:
1. Read all instructions before attempting to install this product.
2. For indoor use only. Do not install this product in damp or wet locations.
3. Regularly check the cords, power supply, light source, and all other parts for damage. If any part is damaged do not use
or install this product.
4. Ensure main power is off before installing or wiring this product.
5. Disconnect electrical power before adding to or changing the configuration of this product.
6. The light sources are non-changeable light emitting diodes (LED). Do not disassemble this product.
www.jescolighting.com
Instruction sheet subject to
change without prior notice
Rev 3
4/2/2012
Page 1 of 4
INSTALLATION INSTRUCTIONS • ORIONIS SERIES
KIT-SD122 – ORIONIS SURFACE MOUNT
www.jescolighting.com
Instruction sheet subject to
change without prior notice
Rev 3
4/2/2012
Page 2 of 4
INSTALLATION INSTRUCTIONS • ORIONIS SERIES
KIT-SD122 – ORIONIS SURFACE MOUNT
www.jescolighting.com
Instruction sheet subject to
change without prior notice
Rev 3
4/2/2012
Page 3 of 4
INSTALLATION INSTRUCTIONS • ORIONIS SERIES
KIT-SD122 – ORIONIS SURFACE MOUNT
www.jescolighting.com
Instruction sheet subject to
change without prior notice
Rev 3
4/2/2012
Page 4 of 4