Hampton Bay PHOTOCELL Instructions / Assembly

INSTALLING THE NEW PHOTOCELL SWITCH
DUSK TO DAWN PHOTOCELL SWITCH
DUSK-TO-DAWN
REPLACEMENT INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a later date.
5. Insert the new photocell neck through hole that was vacated by the old photocell
switch. Adjust the hex nut on the neck, such that enough of the neck protrudes out
from the hole to allow the decorative nut to thread onto the neck.
neck
6. Using one of the wire nuts, attach the short wire of the photocell switch to the black
wire of the fixture.
CAUTION
Turn off the main power at the circuit breaker before replacing the photocell, in order to
prevent possible shock.
REINSTALLING THE FIXTURE
GENERAL
7. Using one of the wire nuts, attach the long wire of the photocell switch to the black
supply wire of the building/house. Using the last wire nut, attach the white fixture
wire to the white supply wire.
All electrical connections must be in accordance with local and National Electrical Code
(N.E.C.) standards. If you are unfamiliar with proper electrical wiring connections obtain
the services of a qualified electrician.
8 C
8.
Carefully
f ll pushh the
h wire
i connections
i
into
i
the
h outlet
l box.
b
Place
Pl
the
h fixture
fi
over the
h
outlet box and secure it onto the mouting bracket using the thumb nuts.
Remove the parts from the box and make sure that no parts are missing by referencing the
illustrations on the installation instructions.
9. Turn on the power at the main circuit breaker box.
INSTALLATION IS NOW COMPLETED
FIXTURE UNINSTALLATION
1. CAUTION: Turn off the power at the main circuit breaker box prior to
performing the photocell replacement to prevent possible shock.
2 R
2.
Remove the
th fixture
fi t
f
from
th wall
the
ll by
b loosening
l
i the
th fixture’s
fi t ’ thumb
th b nuts.
t Carefully
C f ll pull
ll
the fixture from the wall. Leave the existing mounting bracket on the outlet box.
Untwist the wire nuts to disconnect the fixture from the building/ house supply wires.
Keep the thumb nuts and wire nuts.
UNINSTALLING THE EXISTING PHOTOCELL SWITCH
3. Loosen the decorative nut. Untwist the wire nut to disconnect the photocell wire from
the black fixture wire.
4. Pull the photocell switch from the fixture canopy. Discard the photocell switch. Keep
the wire nut and decorative nut.