Hampton Bay 43041 Instructions / Assembly

SOLAR DECK LIGHT
Use and Care
Guide
ITEM #10000XXXX
MODEL #43031
TOOLS REQUIRED
HARDWARE INCLUDED
Phillips
screwdriver
AA - Wood Screw x 2
Electric drill
BB - Plastic Anchor x 2
Installation
1
□
□
□
2
Wood post/fence mounting
To mount the solar light to a wood post or fence, measure
and mark on the wood surface at the locations of both
mounting screws 2 in. on-center.
Insert the mounting screws (AA) into the wood post or fence
at the marked locations, leaving about 1/4 in. of the screws
(AA) sticking out of the wood surface.
Align and place the two mounting holes on the back plate of
the solar light over the mounting screws (AA).
□
□
□
□
IMPORTANT: Prior to use, pull out the top cap (A) from the
lamp housing (B). Then, remove the battery isolator tag (C)
inserted in the battery compartment. Replace the top cap
back to the lamp housing and allow to charge a full sunny
day.
IMPORTANT: Ensure the mounting location for your solar
light allows the solar panel to receive direct sunlight. Do not
locate the product in shaded areas as this will significantly
reduce performance.
NOTE: The solar light is equipped with a photosensor that
turns the unit on at dusk and off at dawn. Ambient light can
affect the operation of the photosensor.
2
To mount the solar light to a concrete wall, measure and
mark on the wall at the locations of both mounting screws 2
in. on-center.
Drill two holes on the wall at the marked locations.
Insert the plastic anchors (BB) into the holes. Insert the
mounting screws (AA) into the anchors (BB), leaving about
1/4 in. of the screws (AA) sticking out of the wall surface.
Align and place the two mounting holes on the back plate of
the solar light over the mounting screws (AA).
IIMPORTANT: Prior to use, pull out the top cap (A) from the
lamp housing (B). Then, remove the battery isolator tag (C)
inserted in the battery compartment. Replace the top cap
back to the lamp housing and allow to charge a full sunny
day.
IMPORTANT: Ensure the mounting location for your solar
light allows the solar panel to receive direct sunlight. Do
not locate the product in shaded areas as this will
significantly reduce performance.
1
Wall mounting
NOTE: The solar light is equipped with a photosensor that
turns the unit on at dusk and off at dawn. Ambient light can
affect the operation of the photosensor.
4
3
2
1
A
C
4
3
A
C
2"
B
2"
AA
B
AA
Safety Information
WARNING: Your solar light may not function in temperatures
below -4ºF (-20ºC) or above 140ºF (60ºC.
CAUTION: Use a rechargeable battery only. Recycle or
dispose of batteries properly.
CAUTION: Do not open, short circuit, or mutilate batteries as
injury may occur.
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Maintenance
Replacing the battery
NOTE: Use one AA size, 500mAh, 1.2V Nickel Metal
Hydride rechargeable battery. For best performance, replace
with a Nickel Metal Hydride rechargeable battery annually.
A
D
IMPORTANT: Dispose of the battery in accordance with
local, state, and federal regulations.
E
IMPORTANT: When storing any solar product for an
extended period of time, remove the batteries. Storing any
solar product without regular recharge or removal of
batteries could cause permanent damage to the
rechargeable batteries.
□
□
□
B
Hold the lamp housing (B), press both sides of the frame top,
then pull out the top cap (A) from the lamp housing (B).
Remove the battery cover (E) and the old battery (D).
Replace with a new Nickel Metal Hydride rechargeable
battery – The recommended replacement battery capacity
should be 500~600mAh.
Replace the battery cover (E). Place the top cap (A) back to
the lamp housing (B) until it locks in place.
Troubleshooting
Problem
The nightly run time
is shorter.
Possible Cause
The battery is not fully charged.
The battery is reaching the end of its useful life.
The solar light does
not turn on at night.
Your solar light is inserted with a battery isolator
tag in the battery compartment. This isolator tag
must be removed prior to use.
The solar light is installed close to other light
sources, which may keep the solar light from
turning on at night automatically.
Solution
Ensure the solar light is located in an area where it
can receive the maximum amount of full, direct
sunlight every day. Keeping the solar panel clean is
equally important to ensure the maximum charging
performance.
Replace the old battery with a Nickel Metal Hydride
rechargeable battery.
Prior to use, check that the battery isolator tag has
been removed from the unit and the unit is allowed to
charge a full sunny day.
Relocate the fixture or eliminate other light sources.
Care and Cleaning
□
□
The solar panel should be cleaned periodically with a damp cloth to help maintain optimum performance.
Do not use any cleaners with chemicals, solvents, or harsh abrasives.
Warranty
ONE YEAR LIMITED WARRANTY
WHAT IS COVERED
The manufacturer warrants this product to be free of defects in material and workmanship for a period of one (1) year from the date of
purchase. This warranty only applies to the original consumer purchaser and only to products used in normal use and service. The
manufacturer’s only obligation and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion,
provided that the product has not been damaged through misuse, abuse, accident, modification, alteration, neglect, or mishandling.
Proof of purchase and evidence of manufacturer’s date coding must accompany all warranty claims. Manufacturer’s date coding is
printed and adhered to each product.
WHAT IS NOT COVERED
This warranty does not apply to products that are found to have been improperly installed, set-up, or used in any way not in accordance
with the instructions supplied with the product. This warranty does not apply to a failure of the product as a result of an accident,
misuse, abuse, negligence, alteration, or faulty installation. Batteries supplied with this product are not included in this warranty. This
warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as this is considered normal
wear and tear. The manufacturer does not warrant and specially disclaims any warranty, whether express or implied, of fitness for a
particular purpose, other than the warranty contained herein. This warranty does not cover consequential or incidental loss or damage,
including but not limited to any labor/expense costs involved in the replacement or repair of the product.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.hamptonbay.com.
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
AA - Tornillo de
madera x 2
□
□
□
□
□
BB - Ancla plástica x 2
□
□
2
1
4
3
2
1
A
C
4
3
A
C
2"
B
2"
AA
B
AA
A
D
E
□
□
□
□
□
B
Download PDF
Similar pages
Trust Helios
Radio Shack Silicon Solar Cell 276-0124 User's Manual
Powerplus Seal
Eglo SOLAR
Eglo 47831
Eglo SOLAR
Eglo SOLAR