Hampton Bay 43041 Use and care guide
Add to My manuals4 Pages
Hampton Bay 43041 is a solar deck light designed for illuminating outdoor spaces. With its built-in photosensor, it automatically turns on at dusk and off at dawn, providing reliable lighting throughout the night. The included rechargeable battery stores solar energy during the day, ensuring long-lasting illumination. Installation is simple, with options for mounting on wood posts, fences, or concrete walls. Its compact size and elegant design make it a suitable lighting solution for decks, patios, gardens, and other outdoor areas.
advertisement
SOLAR DECK LIGHT
ITEM #10000XXXX
MODEL #43031
Use and Care
Guide
HARDWARE INCLUDED TOOLS REQUIRED
Phillips screwdriver
Electric drill
AA - Wood Screw x 2 BB - Plastic Anchor x 2
Installation
1
1
Wood post/fence mounting
□
To mount the solar light to a wood post or fence, measure and mark on the wood surface at the locations of both mounting screws 2 in. on-center.
□ Insert the mounting screws (AA) into the wood post or fence at the marked locations, leaving about 1/4 in. of the screws
(AA) sticking out of the wood surface.
□
Align and place the two mounting holes on the back plate of the solar light over the mounting screws (AA).
2
Wall mounting
□
To mount the solar light to a concrete wall, measure and mark on the wall at the locations of both mounting screws 2 in. on-center.
□ Drill two holes on the wall at the marked locations.
□
Insert the plastic anchors (BB) into the holes. Insert the mounting screws (AA) into the anchors (BB), leaving about
1/4 in. of the screws (AA) sticking out of the wall surface.
□ Align and place the two mounting holes on the back plate of the solar light over the mounting screws (AA).
IMPORTANT: Prior to use, pull out the top cap (A) from the lamp housing (B). Then, remove the battery isolator tag (C) inserted in the battery compartment. Replace the top cap back to the lamp housing and allow to charge a full sunny day.
IMPORTANT: Ensure the mounting location for your solar light allows the solar panel to receive direct sunlight. Do not locate the product in shaded areas as this will significantly reduce performance.
NOTE: The solar light is equipped with a photosensor that turns the unit on at dusk and off at dawn. Ambient light can affect the operation of the photosensor.
2 3 4
IIMPORTANT: Prior to use, pull out the top cap (A) from the lamp housing (B). Then, remove the battery isolator tag (C) inserted in the battery compartment. Replace the top cap back to the lamp housing and allow to charge a full sunny day.
IMPORTANT: Ensure the mounting location for your solar light allows the solar panel to receive direct sunlight. Do not locate the product in shaded areas as this will significantly reduce performance.
NOTE: The solar light is equipped with a photosensor that turns the unit on at dusk and off at dawn. Ambient light can affect the operation of the photosensor.
2 3 4 1
A
C
A
C
2"
B
2"
AA B
AA
Safety Information
WARNING: Your solar light may not function in temperatures below -4ºF (-20ºC) or above 140ºF (60ºC.
CAUTION: Use a rechargeable battery only. Recycle or dispose of batteries properly.
CAUTION: Do not open, short circuit, or mutilate batteries as injury may occur.
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Maintenance
Replacing the battery
NOTE: Use one AA size, 500mAh, 1.2V Nickel Metal
Hydride rechargeable battery. For best performance, replace with a Nickel Metal Hydride rechargeable battery annually.
IMPORTANT: Dispose of the battery in accordance with local, state, and federal regulations.
I MPORTANT: When storing any solar product for an extended period of time, remove the batteries. Storing any solar product without regular recharge or removal of batteries could cause permanent damage to the rechargeable batteries .
□
Hold the lamp housing (B), press both sides of the frame top, then pull out the top cap (A) from the lamp housing (B).
□
Remove the battery cover (E) and the old battery (D).
Replace with a new Nickel Metal Hydride rechargeable battery
– The recommended replacement battery capacity should be 500~600mAh.
□
Replace the battery cover (E). Place the top cap (A) back to the lamp housing (B) until it locks in place.
Troubleshooting
Problem Possible Cause
A
D
E
B
The nightly run time is shorter.
The battery is not fully charged.
The solar light does not turn on at night.
The battery is reaching the end of its useful life.
Your solar light is inserted with a battery isolator tag in the battery compartment. This isolator tag must be removed prior to use.
The solar light is installed close to other light sources, which may keep the solar light from turning on at night automatically.
Solution
Ensure the solar light is located in an area where it can receive the maximum amount of full, direct sunlight every day. Keeping the solar panel clean is equally important to ensure the maximum charging performance.
Replace the old battery with a Nickel Metal Hydride rechargeable battery.
Prior to use, check that the battery isolator tag has been removed from the unit and the unit is allowed to charge a full sunny day.
Relocate the fixture or eliminate other light sources.
Care and Cleaning
□
The solar panel should be cleaned periodically with a damp cloth to help maintain optimum performance.
□
Do not use any cleaners with chemicals, solvents, or harsh abrasives.
Warranty
ONE YEAR LIMITED WARRANTY
WHAT IS COVERED
The manufacturer warrants this product to be free of defects in material and workmanship for a period of one (1) year from the date of purchase. This warranty only applies to the original consumer purchaser and only to products used in normal use and service. The manufacturer’s only obligation and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident, modification, alteration, neglect, or mishandling.
Proof of purchase and evidence of manufacturer’s date coding must accompany all warranty claims. Manufacturer’s date coding is printed and adhered to each product.
WHAT IS NOT COVERED
This warranty does not apply to products that are found to have been improperly installed, set-up, or used in any way not in accordance with the instructions supplied with the product. This warranty does not apply to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation. Batteries supplied with this product are not included in this warranty. This warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and specially disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than the warranty contained herein. This warranty does not cover consequential or incidental loss or damage, including but not limited to any labor/expense costs involved in the replacement or repair of the product.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.hamptonbay.com.
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
□
□
□
AA - Tornillo de madera x 2
BB - Ancla plástica x 2
□
□
□
□
1
A
C
B
2
2"
3
AA
4
1
A
C
B
2
2"
3
AA
4
□
□
□
□
□
A
D
E
B
advertisement
Related manuals
advertisement