the great outdoors by Minka Lavery 9801-144 Installation Guide

INSTALLATION INSTRUCTIONS FOR 9801
For Wall Sconce Fixture
WARNING! SHUT
POWER OFF
AT
MOUNTING THE FIXTURE (Fig.1)
1. Shut off power at the fuse box or circuit breaker box. If
necessary, remove the old fixture and all mounting
hardware from wall junction box.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Attach the crossbar to the junction box with the two
junction box screws as shown. The side of the
crossbar marked “GND” must face out.
4. Thread the nipple part way into the center hole of the
crossbar. The length of the nipple into the crossbar
may be adjusted if necessary.
CONNECTING THE WIRES (Fig.2)
5. Connect the electrical wires as shown in Fig. 2. Make
sure all wire connectors are secured. If your outlet
has a ground wire (green or bare copper), connect the
fixture’s ground wire to the crossbar with the green
screw provided.
COMPLETING THE INSTALLATION (Fig.1)
6. Align the fixture back plate to the nipple and secure
with
the cap nut provided
7. Notice: To comply with UL Standards and maintain
product warranty, use clear silicone sealant to outline
the outside of the fixture back plate where it meets the
wall to prevent moisture from entering the junction
box while leaving a space at the bottom to allow
moisture to escape (Fig 3.). Failure to do so will void
any expressed warranty.
8. Install the light bulbs in accordance with the fixture’s
specification: DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
9. Place the glass with the marked arrow on the topside
into the fixture and secure the steel glass support bar with
the screws and plastic washer provided.
10.
Your installation is now complete. Return power
to the junction box and test the fixture.
FUSE
OR CIRCUIT BREAKER .