the great outdoors by Minka Lavery 72400-615B Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 72400
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
HANGING THE FIXTURE (Fig. 1)
Fig. 1
1. Shut off the power at the circuit breaker and remove the old
fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Attach the crossbar (C) to the outlet box (A) (not supplied)
with mounting screws (B) (Size: #8-32*0.78"L).
4. Thread the nipple (E) into the crossbar (C). Note: The
length of nipple (E) into crossbar (C) may be adjusted if
necessary.
A
CONNECTING THE WIRES (Fig. 2)
Set A # A-016
-Cross bar
-Ground screw
-Mounting screws(2)
COMPLETING THE INSTALLATION (Fig. 1)
6. Align fixture (G) onto crossbar (E), and secure with the lock
nut (F).
7. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e. Indoor/Outdoor
Silicone Sealant) to outline the outside of fixture back plate
where it meets the wall leaving a space at bottom to allow
moisture a means to escape. (Fig. 3)
8. Install bulbs (D) (2 x GU10 35W included.) DO NOT
EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the junction box
and test the fixture.
D
F
E
5. Connect the electrical wires as shown in Fig.2 making sure
that all wire connectors are secured. If your outlet box has
a ground wire (green or bare copper), connect the fixture’s
ground wire to it. Otherwise, connect the fixture’s ground
wire directly to the circular strap using the green screw
provided.
G
B
C
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or
Bare
Copper(Gr
ound)
Fig. 3
Caulking
Backplate