Minka Lavery 2933-84-L Instructions / Assembly

INSTALLATION INSTRUCTIONS
FOR 2933-L
For LED Wall Mount Fixture
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AV E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D O D I S J O N C T E U R .
PREPARATION
1.
2.
3.
Shut off power at the fuse box or circuit breaker box. If
necessary remove the existing fixture and its mounting
hardware from the wall.
Carefully remove the new fixture from the carton and check
that all parts are included as shown in the illustration.
Position mounting plate (A) on the wall, and mark the
location of the two drywall anchors (G). Pre-drill the holes for
the drywall anchors (G). Then insert the drywall anchors (G)
into the wall.
Fig.1F
HANGING THE FIXTURE (Fig.1)
4.
5.
Attach the mounting plate (A) to the outlet box using outlet
box screws (B) (Size: 8-32*1/2’’L). The side of the mounting
plate marked “GND” must face out.
Place the wood screws (F) through the holes of the
mounting plate (A) and into the drywall anchors (G) to
secure the mounting plate (A) to the wall.
CONNECTION THE WIRES (Fig. 2)
6.
At this point, connect the electrical wires as shown in Fig.2,
making sure that all wire connectors are secured. If your
outlet box has a ground wire (green or bare copper), connect
the fixture's ground wire to it. Otherwise, connect the
fixture's ground wire directly to the mounting plate using the
green screw provided. After the wires are connected, tuck
them carefully into the outlet box.
Fig.2
FINISHING THE INSTALLATION (Fig. 1)
7.
Align Fixture (E) over mounting plate (A) and secure with
screws (D).
Your installation is now complete. Return power to the outlet box
and test the fixture.
CAUTION /ATTENTION: When handling the fixture, do not
apply pressure to the LEDs. Hold the fixture by the base or
fixture body (E) only.
Fig.3
Replacing LED module (Fig.3)
The LED module can be replaced by a qualified electrician without
cutting the wires and without damaging the decorative element to
which the fixture is attached. See installation steps for more details
(Fig 3.)
Warning: Turn off power at the fuse box or circuit breaker
before replacing LED module.
a.
To remove the fixture from the wall: loosen screws (D), and
remove the wire connectors. Then place the fixture on a clear
flat surface.
b.
Loosen screws (P), hex nuts (F) screws (M), wire fastener (N)
and then carefully remove LED module (I).
c.
Reverse steps a-b for installing the new LED module.
Note: The LED module should be provided by a specified supplier.
II 798
IMPORTANT: Fixture should be installed by a
qualified electrician to ensure proper wiring and
installation.
Dimmable with C-L (CFL & LED) type and
Incandescent/Halogen type dimmers