Minka Lavery 6763-211 Installation Guide

INSTALLATION INSTRUCTIONS
11/11/2006
WARNING!
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
Fig. 1
MOUNTING THE BACKPLATE (Fig.1)
H
1. Shut off the power at the circuit breaker and remove
old fixture, including the mounting hardware.
G
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Attach the Back-plate (A) to the Junction box with the
Junction box Screws (B). The side of the Back-plate
marked “GND” must face out.
C
E
F
D
A
CONNECTING THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig. 2, making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s Ground Wire to it. Otherwise, connect the
fixture’s Ground Wire directly to the Back-plate using
the Green Screw provided. After the wires are
connected carefully tuck them inside the Junction box.
B
Fig. 2
FINISH MOUNTING FIXTURE (Fig.1)
5. Place the Fixture Body (E) over the Back-plate (A), and
secured with Allen Screws (D) by the Wrench (C).
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
6. Place Shade (F) and Metal Tube (G) onto the lamp
socket and secure with Screw Shell (H) tightly.
7. Install light bulbs in accordance with fixture
specifications, (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!)
Your installation is now complete. Return power and
test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased
LA-1050E
HOUSE
WIRES
Black
(Hot)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)