Minka Lavery 4740-206 Installation Guide

INSTALLATION INSTRUCTIONS FOR 4740-206
Read and save these instructions
WARNING!
SHUT POWER
OFF AT FUSE OR
CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
Wiring (see fig.2)
1. Disconnect power at main electrical panel before
installation.
2. Thread the two mounting screws about 1/4” into the
pre-drilled holes in the mounting plate, spaced about the
same distance apart as the holes in the fixture back
plate. Attach the mounting plate to the junction box
using two junction box screws. The side of the
mounting plate marked “GND” must face out.
3. Guide fixture wires through hole in center of mounting
plate.
4. Follow wiring instructions carefully (see fig.2).
5. Mount fixture by aligning mounting holes in fixture
back plate with mounting screws and threading ball nuts
(D) onto mounting screws.
6. Place the glass panel (C) and the glass shade (A) into
the metal trim (B).
7. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
1. Connect the electrical wires as follows. Connect the Black
wire from the fixture to the black house (hot) wire.
Connect the white wire from the fixture to the white
(neutral) house wire. Make sure all wire nuts are secured.
You may wrap the connections with electrical tape. If
your outlet box has a ground wire (green or bare copper)
connect fixture’s ground wire to it. Otherwise attach the
bare copper fixture wire to the green ground screw on the
mounting plate.
2. Tuck the wire connections neatly into the wall junction
box.
Fig.1
Fig.2
MIN 90ºC SUPPLY CONDUCTORS
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
HOUSE (Ground) HOUSE
WIRES
WIRES
Green or
White
Bare Copper(Ground)
(Neutral)