Minka Lavery 6562-77 Installation Guide

INSTALLATION INSTRUCTION FOR FIXTURE
6562-77,6563-77, 6564-77
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT OFF THE POWER AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE
Wiring (See fig.2)
1. Shut off the power supply at the fuse box or circuit
1. Connect the electrical wires as follows. Connect the
breaker box. Remove the old fixture from wall.
black wire from the fixture to the black (HOT) house
Including the old cross bar.
wire. Connect the white wire from the fixture to the
2. Carefully unpack your new fixture and lay out all the
white (Neutral) house wire. Make sure all the wire
parts in a clear area. Take care not to lose any small
nuts were secured. You may wrap the connections
parts necessary for installation.
with electrical tape. If your outlet box has a ground
3. Thread the mounting screw (C) into the mounting
wire (Green or Bare Copper) connect fixture’s
holes on the mounting plate (A) well and secure with
ground wire to it. Other wise attach the bare copper
hex nut (D).
fixture wire to the green ground screw on the
4. Attach the mounting plate (A) to the outlet box using
mounting plate.
the outlet box screws(B). The side of the mounting bar
2. Tuck the wire connections neatly into the wall
marked “GND” must face out.
junction box.
5. Follow the wiring instructions carefully (See Fig.2).
6. Attach the fixture back plate(J) over the mounting
plate (A) by protruding the mounting screw(C) through Fig.2
the mounting hole of the back plate(J) and secure with
nut(I).
7. Put the glass shade (G) over the socket (H) and
secure with socket ring (F).
8. Install the bulb in accordance with fixture’s
specifications. DO NOT EXCEED THE MAXMUM
WATTAGE RATING!
Your installation is now complete. Return power to the
juction box and test the fixture.
Fig.1
OUTLET BOX
SUPPLY WIRE
(B)OUTLET BOX SCREWS
(A) MOUNTING PLATE
GROUND WIRE
GREEN GROUND SCREW
(C) MOUNTING SCREW
HEX NUT(D)
WIRE NUT
BACK PLATE (J)
SOCKET RING(F)
GLASS SHADE(G)
SOCKET(H)
NUT (I)