Minka Lavery 5943-126 Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR 5943-126
For Wall Mount Fixture
WARNING!
SHUT POWER
OFF AT FUSE OR
CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
Wiring (see fig.2)
1.Disconnect power at main electrical panel before 1.Connect the electrical wires as follows. Connect the
installation.
Black wire from the fixture to the black house (hot)
2.Attach the mount plate to the junction box using two
Wire. Connect the white wire from the fixture to the
junction box screw. The side of the mounting plate marked
white (neutral) house wire. Make sure all wire nuts are
“GND” must face out.
secured. You may wrap the connections with electrical
3.Guide fixture wires through hole in center of mounting plate
tape. If your outlet box has a ground wire (green or bare
4.Follow wiring instructions carefully (see fig.2)
copper) connect fixture’s ground wire to it. Other wise
5.Mount fixture by aligning mounting holes in fixture back
attach the bare copper fixture wire to the green ground
plate with mounting screws and threading ball nuts(E)
screw on the mounting plate.
onto mounting screws.
2.Tuck the wire connections neatly into the wall
6.Attach the glass shade(B) and collar ring(C) on lamp
junction box.
holder, then lock it securely with check ring(D).
7.Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
Fig.1
Fig.2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
HOUSE (Ground) HOUSE
WIRES
WIRES
Green or
White
Bare Copper(Ground)
(Neutral)
UL
R
Listed
american
lighting
association