Minka Lavery 5551-477 Installation Guide

INSTALLATION INSTRUCTIONS FOR 5551-477
For Wall Mount Fixture
WARNING!
SHUT POWER
OFF AT FUSE OR
CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
Wiring (see fig.2)
1.Disconnect power at main electrical panel before
installation.
2.Attach the mounting plate to the junction box using two
junction box screw. The side of the mounting plate
marked “GND” must face out.
3.Guide fixture wires through hole in center of mounting
plate
4.Follow wiring instructions carefully (see fig.2)
5.Mount fixture by aligning mounting holes in fixture back
plate with mounting screws and threading ball nuts (C)
onto mounting screws.
6.Hold the glass shade (A) through the lamp body (B), and
then secure the glass shade in. Place by turning the glass
shade in arrow direction.
7.Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
1.Connect the electrical wires as follows. Connect the
Black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the
white (neutral) house wire. Make sure all wire nuts are
secured. You may wrap the connections with electrical
tape. If your outlet box has a ground wire (green or bare
copper) connect fixture’s ground wire to it. Otherwise
attach the bare copper fixture wire to the green ground
screw on the mounting plate.
2.Tuck the wire connections neatly into the wall junction
box.
Fig.1
Fig.2
MIN 90℃ SUPPLY CONDUCTORS