Minka Lavery 9147-407 Instructions / Assembly

INSTALLATION INSTRUCTIONS
Model # 9147
READ AND SAVE THESE INSTRUCTIONS
W ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
1. Shut off power at the circuit breaker and remove old
fixture including mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Make two holes on the wall in correct position
in
accordance with the long strap (C) and the outlet box
(A), then insert the anchor (E) into the hole.
4. Pull black and white wires out of electrical outlet box
(A).
5. Thread the four studs (B) into the pre- drilled holes in the
long strap (C) spaced the same distance apart as the
holes in the back plate (F).
6. Attach long Strap (C) using Outlet Box Screws (D
) to
the outlet box (A) , screw the wood screws (G) into the
anchor (E) (Fig 1).
7. Connect the electrical wires as shown in Fig.2. M aking
sure that all wire conne ctors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture ’s Ground wire to it. Otherwise, connect the
fixture’s Ground wire directly to the long strap using the
Green Screw (H) provided.
8. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone Sealant to
outline the outside of fixture back plate (F) where it
meets the wall leaving a space at bottom to allow
moisture a means to escape.
9. Place the back plate (F) into stud (B) and secure it
tightly against the wall using cap nut (I). (Fig 1)
10. At this point, screw the extended nut (N), remove the
cage (M) to install the light bulbs in accordance with the
fixture specification. –-DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!
11. Replace the cage (M), tighten with the extended nut
(N),then screw the nipple(O) and secure with the bottom
finial(P).
12. Replace the rubber washer (L), secure the top finial (J)
with the nipple (K).
Fig. 1
I
B
C
A
J
K
L
D
H
E
G
F
M
N
O
P
Fig.2
FIXTURE
WIRES
GREEN OR
BARE
COPPER
(GROUND)
FIXTURE
WIRES
WHITE
FIXTURE
WIRES
BLACK
HOUSE
WIRES
BLACK
(HOT)
HOUSE
WIRES
WHITE
(NEUTRAL)
HOUSE
WIRES
GREEN OR
BARE COPPER(GROUND)
Your installation is now complete. Return power to the
outlet box and test the fixture.
R
“CAUTION-RISK OF FIRE, CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”