Minka Lavery 4878-283 Instructions / Assembly

INSTALLATION INSTRUCTIONS
WARNING! SHUT
Item#4878-283 (New. 05/ 10/ 2014)
READ AND SAVE THESE INSTRUCTIONS
POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.2)
Fig.1
1. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the existing fixture and its mounting
hardware from the ceiling.
2. Carefully remove the new fixture from the carton and check that
all parts are included as shown in the illustration.
3. Remove the screw (B), and remove the outer frame (J).
4. Insert the front glass (D) and side glass (E) into the outer frame
(J) then secure the glass with clips (F).
5. Place the fixture body (C) into the outer frame (J), and secure with
screws (B).
6. Install the light bulbs (not included) in accordance with the
fixture’s specifications: DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
MOUNTING THE FIXTURE (Fig.1)
7. Thread one end of nipple into the crossbar until snug.
8. Place lock washer and hex nut over end of nipple protruding
through crossbar, then thread hex nut until tight.
9. Take this crossbar assembly and mount to the ceiling outlet box
using the mounting screws (Size: #8-32N*L0.5”). The side of
the crossbar marked “GND” must face out.
10. Open the quick links and connect to the fixture loops (A). Then
close the quick link.
11. By measuring, determine the correct number of links needed on
each chain for the desired hanging height. Using the chain pliers
disconnect and discard the excess chain.
12. Carefully lace the fixture wires through the chain.
13. Open the other quick links to connect the other end links of the
chains to the ceiling loops on the canopy. Then close the quick
links.
14. Feed the fixture wires through the ceiling loop and canopy and
pull tight.
Set# A-014
- Crossbar
- Ground Screw
- Mounting Screw*2
Fig.2
CONNECTING THE WIRES (Fig.3)
15. Raise the fixture to the ceiling and hook the safety cable onto
the crossbar.
16. Connect the electrical wires as shown in figure 3, making sure
that all wire connectors are secured. If your outlet box has a
ground wire (green or bare copper), connect the fixture’s ground
wire to it. Otherwise, connect the fixture’s ground wire directly to
the circular strap using the green screw provided. After wires are
connected, tuck them carefully into the ceiling junction box.
FINISHING THE INSTALLATION (Fig. 1)
17. Place the canopy onto the nipple and secure it with the finial.
Your installation is now complete. Return power to the junction box
and test the fixture.
Note: Illustration (Fig.1) (Fig.2) on this manual is for
installation purposes only. It may or may not be identical to the
fixture purchased.
CHAIN HUNG FIXTURE INSTRUCTION
Notice: It is important to use proper chain pliers (not
included) To OPEN and CLOSE the chain included with this
fixture. Do not open them with other tools that may twist or
stress the chain links. It is important to use proper chain
pliers like the ones shown in the diagram.
Chain # HCH2072-283
Gauge D3.8mm
Fig.3
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
HOUSE (Ground) HOUSE
WIRES
WIRES
Green or
White
Bare Copper(Ground)
(Neutral)
CM
C
US
lntertek