Minka Lavery 4416-281 Instructions / Assembly

INSTALLATION INSTRUCTIONS
Item#4416-281 (New. 01/13/2015)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton and check
that all parts are included as shown in the illustration.
2. Shut off power at the circuit breaker and remove the
old fixture including the mounting hardware.
3. Determine the hanging height desired and connect
down rods (J&K) to nipple (S), then secure the swivels
(I) to the top of the down rods (J).
4. Next place canopy (H), metal plate (S), lock washer
(C) and washer (D) over the top of swivel (I). Fasten
with hex nut (E) by using the wrench (F) provided.
5. Position the mounting plate (A) on the ceiling, and
mark the location of the two drywall anchors (A).
Pre-drill the holes for the drywall anchors (A) and
insert the drywall anchors (T) into the ceiling.
6. Attach the mounting plate (A) to the outlet box with
screws (B) (size: #8-32N*L0.5”). The side of the
mounting plate marked “GND” must face out.
7. Place the woodscrews (U) through the mounting plate
and into the drywall anchors (T) to secure the
mounting plate (A) to the ceiling.
CONNECTING THE WIRES (Fig. 2)
8. Connect the electrical wire as shown in (Fig.2),
making sure that all wire connectors are secured. If
your outlet box has a ground wire (green or bare
copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture ground wire directly to
the circular strap using the green screw provided.
COMPLETING THE INSTALLATION (Fig. 1)
9. Place the Canopy (H) over Mounting plate (A) and
fasten with screws (G).
10. Place the glass shade (F) followed by metal ring (G)
over the socket, fasten with screw shell (H) by using
the tool (I).
11. Install the A19 1*100W (MED BASE) light bulb (not
included)
in
accordance
with
the
fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
Fig. 1
Rod#W30-1-281*6(J)
30-H-281*2(K)
T
B
E
A
F
D
U
S
G
H
C
I
J
O
K
N
L
M
S
Socket Ring#SKT-RING-26SKT-RING-26
E26 Socket Spanner: WRH-1-51
Your installation is now complete. Return power and
test the fixture.
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-2437E
E
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)