Minka Lavery 1541-77 Instructions / Assembly

INSTALLATION INSTRUCTIONS
Item#1541 (New. 08/29/2013)
READ AND SAVE THESE INSTRUCTIONS
W ARNING !
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the fuse box or circuit
breaker. If necessary, remove the old fixture
including the mounting hardware.
2. Carefully remove the fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Attach the mounting plate (A) to the outlet box
using mounting screws (C) (Size: #8-32N*L0.5”).
The side of the mounting Plate marked “GND”
must face out.
4. Determine the desired hanging height and thread
rods (F) to metal frame (G). Carefully pass the
wires through each rod as you assemble. Then
attach loop (E) by screwing onto rods (F). Note:
remove the nipple if installing with one 6” rod only.
5. By measuring, determine correct number of links
needed for proper hanging height. Using pliers,
disconnect and discard remaining chain, then
attach the chain to the loop (E) and the loop on
canopy (D). Then carefully lace the fixture wires
through the chain, loop (E) and the loop of canopy
(D).
Fig. 1
Outlet Box
A
B
C
D
Rod# W35-1*3(F)
W35-H*1(F)
Set# A-021-126102
- Mounting Plate
- Ground Screw
- Mounting Screw*2
CONNECTING THE WIRES (Fig. 2)
6. At this point, connect the electrical wire as shown
in figure 2, making sure that all wire connectors
are secured. If your outlet box has a ground wire
(green or bare copper), connect the fixture’s
ground wire to it. Otherwise, connect the fixture’s
ground wire directly to the mounting plate using
the green screw provided.
FINISHING THE INSTALLATION (Fig. 1)
7. Place canopy (D) over the mounting plate (A) and
secure with screws (B).
8. Place the glass shade (H) and metal ring (K) over
the socket and secure with socket ring (I) by using
spanner (J) provided.
9. Install light bulb (not included) in accordance with
the fixture’s specifications. (DO NOT EXCEED
THE MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER
LA PUISSANCE
NOMINALE
MAXIMALE!)
Your installation is now complete. Return power to
the outlet box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-1817E
E
Chain + Loop
# HCH2012
F
G
H
K
I
J
Spanner # WRH-T1-51
Socket Ring # SKT-RING-26
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)