Minka Lavery 1562-477 Installation Guide

INSTALLATION INSTRUCTIONS FOR 1562-477
For Wall Mount Fixture U.S. Patent No.: D530, 850
WARNING!
SHUT POWER
OFF AT FUSE OR
CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
Wiring (see fig.2)
1. Shut off the power at the circuit breaker and remove old fixture,
including the mounting plate.
2. Thread the two mounting screws about 1/4” into the pre-drilled
holes in the mounting plate, spaced about the same distance apart
as the holes in the fixture back plate. Attach the mounting plate to
the junction box using two junction box screws. The side of the
mounting plate marked “GND” must face out.
3.Follow wiring instructions carefully (see fig.2)
4. Mount fixture by aligning mounting holes in fixture back plate
with mounting screws and threading ball nuts (A) onto mounting
screws.
5. Place the socket sleeve (C) over the socket (B).
6. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
7. Clip the cloth shades (D) on to the bulbs.
1.Connect the electrical wires as follows. Connect the
black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the
white (neutral) house wire. Make sure all wire nuts are
secured. You may wrap the connections with electrical
tape. If your outlet box has a ground wire (green or bare
copper) connect fixture’s ground wire to it. Otherwise
attach the bare copper fixture wire to the green ground
screw on the mounting plate.
2.Tuck the wire connections neatly into the wall junction
box.
Fig.1
Fig.2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
HOUSE (Ground) HOUSE
WIRES
WIRES
Green or
White
Bare Copper(Ground)
(Neutral)