Minka Lavery 4137-84 Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR 4137
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
PREPARATION (Fig. 1)
1. Shut off the power at the fuse box or circuit
breaker. If necessary, remove the old fixture
including the mounting hardware.
2. Carefully remove the new fixture from the carton
and check that all parts are included as shown in
the illustration.
MOUNTING THE FIXTURE (Fig.1)
3. Raise the mounting bracket (A) to the junction
box (not provided), then secure with the junction
box screws (B) (Size: #8-32*0.6”L). The side of
the mounting bracket marked “GND” must face
out.
CONNECTING THE WIRES (Fig. 2)
4. At this point, connect the electrical wires as shown
in Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire
(green or bare copper), connect the fixture’s ground
wire to it. Otherwise, connect the fixture’s ground
wire directly to the mounting bracket using the
green screw provided. After the wires are
connected, tuck them carefully inside the outlet
box.
COMPLETING THE INSTALLATION
5. Raise the canopy (C) over the mounting bracket
(A), and secure it with mounting screws (D)
(Size:#8-32*0.5”L).
6. Install the light bulbs (Included) in accordance
with the fixture’s specification. (DO NOT
EXCEED THE MAXIMUM WATTAGE RATING!)
(NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!).
Fig.1
Set# A-021-193D
- Hanging bracket
- Ground screw
- Mounting screws*3
- Junction box screws*2
A
B
C
E
F
Note: Press spring coupling (E) by hand and
adjust to the desired length of steel wire (F).
Your installation is now complete. Return the power
to the junction box and test the fixture.
D
Fig.2