Minka Lavery 6391-77 Installation Guide

INSTALLATION INSTRUCTIONS
6391-6392-6393-6394
an READ AND SAVE THESE INSTRUCTIONS 8 |
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE (Fig.1) Fig. 1
1. Shut off the power at the circuit breaker and remove | ee
old fixture, including the mounting hardware. G
2. Carefully remove the fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Attach the Mounting Plate (A) to the Junction Box ! H-—e=
using Junction Box Screws (B). The side of the TT Outlet Box
mounting plate marked “GND” must face out, NA
4. Place the Allen screw (J) over the Plastic Washer C B
(K) , Diffuser Glass Shade (L) and Metal Plate (O) | —D
secure with Metal Frame (E),then place the Screw | — |
(№) through the Plastic Washer {K),Glass Panel (M)
and Metal Plate (1) secure with Metal Frame (E).
5. Install the Xenon bulb (H) (included) in accordance
with the fixture's specifications. (DO NOT EXCEED
THE MAXIMUM WATTAGE RATING!) =
6. Secure the Metal Frame (E) onto the Fixture Body _______
(C) by using Screws (F). Fig. 2
Gran or
ar
CONNECTING THE WIRES (Fig. 2)
7. At this point, connect the electrical wires as shown
in Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green
or bare copper), connect the fixture's Ground Wire
to it. Otherwise, connect the fixture's Ground Wire
directly to the mounting plate using the Green Screw
provided, After wires are connected, tuck them
carefully inside the Junction Box.
oppar [ENE
(GR) {EE
atea)
Fig. 3
FINISHING THE INSTALLATION (Fig.1) 9
8. Place Fixture Body (C) over Mounting Plate (A),
fasten with Screws (D} by using Allen Wrench (G)
provided.
Your installation is now complete. Return power and
test the fixture.
Note: Illustration (Fig.1) on this manual is for
Installation purposes only. It may or may not be
identical to the fixture purchased.
armeri<an
LA-1917E MAA
association