Minka Lavery 4955-267B Instructions / Assembly

INSTALLATION INSTRUCTION FOR 4955
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
SSEMBLING THE FIXTURE (Fig. 2)
1. Shut off the power at the fuse box or circuit breaker. If
necessary, remove old fixture, including the mounting
hardware.
2. Carefully remove the fixture from the carton and check that
all parts are included as shown in the illustration.
3. Remove the decorative ring (A1) from the shade (Y).
4. Place the glass panel (Z) into the decorative ring (A1), then
using the sheet metals (C1) to compact the glass panel (Z).
5. Secure the decorative ring (A1) to the bottom of shade (Y)
with the screws (B1).
6. Thread the rod (O) onto the nipple (P) and the nipple (N).
7. Place the coupling (M) and the tube (L) over the nipple (N),
then secure with the loop (K).
8. Secure the top of the arms (Q) to the coupling (M) with the
screws (R).
9. Secure the lower end of the arms (Q) to the decorative ring
(T) with the screws (S).
10. Install the light bulb(s) (not included) in accordance with the
fixture’s specification. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!).
11. Secure glass panels (U) to iron plate (V) with screws (W)
and plastic washes (X).
HANGING THE FIXTURE (Fig. 1)
12. Thread the nipple (E) into the ceiling loop (G) until snug.
13. Thread hex nut (D) onto nipple (E). Place lock washer (C)
over end of nipple (E).
14. Thread other end of nipple (E) with loop attached into
crossbar (A) until snug.
15. Take this crossbar (A) assembly and mount to ceiling
junction box with mounting screws (B) (Size: #8-32*0.6”L).
The side of the mounting bar marked “GND” must face out.
16. Connect quick link (J) to end of chain (I), then connect
quick link (J) to fixture loop (K).
17. By measuring, determine correct number of links needed
for desired hanging height.
18. Lace the fixture wires through the chain links and slip
screw collar ring (H) and the canopy (F) over the chain.
19. Open one link of the other end of the chain (I) and connect
it to the ceiling loop (G).
20. Feed the fixture wires through the ceiling loop (G) and
nipple (E) and pull until tight.
CONNECTING THE WIRES (Fig. 3)
21. At this point, connect the electrical wires as shown in Fig.
3, making sure that all wire connectors are secured. If your
outlet box has a ground wire (green or bare copper),
connect the fixture’s ground wire directly to it. If not,
connect to the mounting plate using the green screw
provided. After the wires are connected, tuck them
carefully inside the outlet box.
COMPLETING THE INSTALLATION (Fig.2)
22. Raise the canopy (F) all the way to the ceiling. Raise the
screw collar ring (H) and thread onto ceiling loop (G)
protruding through canopy (F). (Fig.1)
Your installation is now complete. Return the power to the
junction box and test the fixture.
Fig.1
Set# A 016
- Crossbar
- Ground screw
- Mounting screw*2
Fig.2
L
K
M
R
N
Q
O
V
W
X
P
S
U
T
Y
C1 B1
Z
A1