Minka Lavery 6561-77 Installation Guide

INSTALLATION INSTRUCTION FOR FIXTURE 6561-77
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT OFF THE POWER AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE
1. Shut off the power supply at the fuse box or circuit
breaker box. Remove the old fixture from wall.
Including the old cross bar.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to lose any small
parts necessary for installation.
3. Thread the nipple (E) into the center hole of the
mounting bar (A) properly, then secure with shake
proof washer (C) and lock nut (D).
4. Attach the mounting bar (A) to the outlet box using the
outlet box screws (B). The side of the mounting bar
marked “GND” must face out.
5. Follow the wiring instructions carefully (See Fig.2).
6. Attach the fixture back plate (J) over the mounting bar
(A) by protruding the nipple (E) through the center
hole of the back plate (J) and secure with finial (K).
7. Put the glass shade (H) over the socket (I) and secure
with socket ring (G).
8. Install the bulb in accordance with fixture’s
specifications. DO NOT EXCEED THE MAXMUM
WATTAGE RATING!
Wiring (See fig.2)
1. Connect the electrical wires as follows. Connect the
black wire from the fixture to the black (HOT) house
wire. Connect the white wire from the fixture to the
white (Neutral) house wire. Make sure all the wire
nuts were secured. You may wrap the connections
with electrical tape. If your outlet box has a ground
wire (Green or Bare Copper) connect fixture’s
ground wire to it. Other wise attach the bare copper
fixture wire to the green ground screw on the
mounting plate.
2. Tuck the wire connections neatly into the wall
junction box.
Fig.2
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
OUTLET BOX SCREWS(B)
SOCKET RING(G)
GREEN GROUND SCREW
MOUNTING BAR(A)
GLASS SHADE(H)
WIRE NUT
OUTLET BOX
SOCKET (I)
FINIAL(K)
SHAKE PROOF WASHER(C)
LOCK NUT(D)
NIPPLE(E)
BACK PLATE(J)