Minka Lavery 977-1-138 Installation Guide

INSTALLATION INSTRUCTIONS
For Models 977-1-138
WARNING!
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
MOUNTING THE FIXTURE
Fig.1
1. Shut off power at the fuse box or circuit breaker box.
Remove the old fixture from ceiling, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to loose any small parts
necessary for installation.
3. Attach the crossbar (B) to the outlet box using the two
screws (C) from the outlet box. The side of the crossbar
marked ”GND” and with two mounting screws must face
out.
4. Thread the two Mounting Screws (A) on crossbar about
1/4", align with the pre-drilled holes in the canopy (D).
5. Feed wire thru rods (F) as required getting desired height.
While holding the center tube (F) turn counter-clockwise
four full turns. Attach each additional center tube (F) by
turning it clockwise until assembled.
6. While holding the canopy (D) toward the ceiling, connect the
electrical wires as follows (See Figure 2).Connect the black
wire from the fixture to the black house (hot) wire. Connect
the white wire from the fixture wire to the white (neutral)
house wire. Make sure all wire nuts are secured. You may
wrap the connections with electrical tape. If your outlet has
a ground wire (green or bare copper), connect fixture’s
ground wire to it. Otherwise connect fixture’s ground wire
directly to the crossbar using the green screw provided.
Tuck the wire connections neatly into the ceiling junction
box as you hold the canopy (D) assembly toward the
ceiling.
7. Place the metal frame (H) and glass shade (J) over the
socket (G).Then secure the glass with retaining ring (I).
8. Attach the canopy (D) onto outlet box and secure it with
nuts (E).
9. Install
the
light
specifications.
bulbs
DO
NOT
in
accordance
EXCEED
with
THE
fixtures
MAXIMUM
WATTAGE RATING!
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or
Bare
Copper(Gr
ound)