Minka Lavery 5130-84 Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR 5130
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
PREPARATION (Fig. 1)
1. Shut off the power at the fuse box or circuit
breaker. If necessary, remove the old fixture
including the mounting hardware.
2. Carefully remove the fixture from the carton and
check that all parts are included as shown in the
illustration.
MOUNTING THE FIXTURE (Fig.1)
3. Thread the two mounting screws (A) (Size: #832*1.6”L) part way into the circular strap (B).
Secure circular strap (B) to the junction box (not
provided) using junction box screws (C) (Size: #832*0.6”L). The side of the circular strap marked
“GND” must face out. The length of mounting
screws (A) into circular strap (B) may be adjusted
if necessary.
CONNECTING THE WIRES (Fig. 2)
4. At this point, connect the electrical wires as
shown in Fig. 2 making sure all wire connectors
are secured. If your outlet box has a ground wire
(green or bare copper) connect fixture’s ground
wire to it. Otherwise, connect the fixture’s ground
wire directly to the mounting plate using the
green screw provided. After the wires are
connected, tuck them neatly inside the junction
box.
COMPLETING THE INSTALLATION (Fig. 1)
5. Mount the fixture body (D) onto mounting screws
(A) and secure with finials (E).
6. Install the light bulbs (Included) in accordance
with the fixture’s specifications (DO NOT
EXCEED THE MAXIMUM WATTAGE!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
Your installation is now complete. Return power to
the junction box and test the fixture.
Fig.1
Set# A-022
- Circular strap
- Ground screw
- Mounting screws*2
- Junction box screws*2
B
A
C
D
E
Fig.2