Minka Lavery 4206-290 Installation Guide

INSTALLATION INSTRUCTIONS FOR 4206-290
WARNING! SHUT
POWER OFF
AT
FUSE
OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.2)
1. Shut off the power at the circuit breaker and remove the old
fixture from ceiling, including the old crossbar.
2. Carefully unpack the new fixture and lay all the parts on a clear
surface.
3. Attach the loop (J) to the column (K) by turning it clock wise
until tight.
4. Attach the column (K) to the fixture body (M) by turning it clock
wise until tight.
5.
Fig.1
Place the tube (L) over the socket of the fixture body (M).
HANGING THE FIXTURE (Fig.1)
6. Thread the nipple (C) into the loop (F) until snug.
7. Thread the other end of the nipple (C) with the loop attached into
the crossbar (D) until snug.
8. Place lock washer (B) over end of nipple protruding through
crossbar and thread hex nut (A) onto nipple until tight.
9. Take this crossbar assembly and mount to ceiling junction box
with junction box screws (E) (Size: #8-32*1"L). Tighten screws
securely with screwdriver.
10. Using proper chain pliers to open one end link of the chain
provided and connect to the fixture loop (J); then close the link.
11. By measuring, determine correct number of links needed for
proper hanging height. Using proper chain pliers disconnect and
discard remaining chain.
12. Lace the fixture wires through the chain.
Fig.2
13. Slip loop collar (H) and canopy (G) over the chain.
14. Open the other end link of the chain and hang the fixture on the
loop at the ceiling. Close the link.
15. Feed the fixture wires through the loop (F) and nipple (C) and
pull until tight.
CONNECTING THE WIRES (Fig.3)
16. Connect the electrical wire as shown in figure 3, making sure
that all wire connectors are secured. If your outlet has a ground
wire (green or bare copper), connect the fixtures ground wire to
it. If the junction box has no ground wire, attach the bare copper
fixture wire to the green ground screw (Screw: #8-32*3/8”L) on
the crossbar. Tuck the wire connections neatly into the ceiling
junction box.
COMPLETING THE INSTALLATION (Fig.2)
17. Install the light bulbs (not included) in accordance with the
fixture’s specifications: DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
18. Raise the canopy (G) all the way to the ceiling; then raise the
loop collar (H) and thread into ceiling loop protruding through
canopy.
CHAIN HUNG FIXTURE INSTRUCTION
Notice: It is important to use proper chain pliers (not
included) To OPEN and CLOSE the chain included with this
fixture. Do not open them with other tools that may twist or
stress the chain links. It is important to use proper chain
pliers like the ones shown in the diagram.
Your installation is now complete. Return power to the junction
box and test the fixture.
Fig.3
FI XTURE
WI RES
Bl ack or
Smoot h
HOUSE
WI RES
Bl ack
( Hot )
FI XTURE
WI RES
Whi t e or
Ri bbed
FI XTURE
WI RES
Bar e
Copper
HOUSE ( Gr ound) HOUSE
WI RES
WI RES
Gr een or
Whi t e
Bar e Copper ( Gr ound)
( Neut r al )
CM
C
US
lntertek