Minka Lavery 6360-281 Installation Guide

 INSTALLATION INSTRUCTION FOR 6360-281
For Wall Mount Light Fixtures
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
READ AND SAVE THESE INSTRUCTIONS
PREPARATION . Fig.1
1. Shut off power at the fuse box or circuit breaker box.
If necessary. Remove old fixture and all mounting
hardware from wall junction box.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to loose any
small parts necessary for installation.
MOUNTING THE FIXTURE (FIG.1)
3. Secure back plate (A) to outlet box (not provided)
with outlet box screws (B) through slotted holes in
back plate.
CONNECTING THE WIRES (Fig. 2)
4. Connect the fixture wires to the junction box wires
as shown in Fig. 2. Make sure all wire connectors
are secure and do not easily pull off with a slight
tug. If there is no Green Ground Wire from the
junction box, connect the Fixture Ground Wire to
the Circular Strap or the Crossbar with the Green
Screw provided.
5. Tuck these wire connections neatly into the wall
junction box.
6. Raise the face plate (C) to back plate (A) ,and the
secure face plate(C) with screws (D) by wrench (E) Fig.2
COMPLETING THE INSTALLATION D> > т >
7. Install the proper light bulbs for your fixture. WEES une de
DO NOT EXCEED THE SPECIFIED WATTAGE! een Hove a
8. Place the glass (1) into the socket (F) with onto the (Sun
small cap (G), then Place the glass (J) into the
glass (I) with onto the big cap (F). ws | WRES | Wes
(Не!) | (Neutral) Bore Capnerleroun)
Return the power to the junction box and test the
fixture. Your installation is now complete.
THY EE : 1:
NGF USN
© Minka Lighting, Inc.
This product Is protected by United States Federal and/or
State Law, including Patent and/or Copyright laws.
но ERR