Minka Lavery 1134-84 Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR 1134-84
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
PREPARATION
1. Shut off power at the fuse box or circuit breaker
box. If necessary. Remove the old fixture including
the mounting hardware.
2. Carefully remove the new fixture from the carton
and check that all parts are included as shown in
the illustration.
ASSEMBLING THE FIXTURE (FIG. 1)
3. Determine the desired hanging height and thread
rods (L, K, J, I) into fixture body (M). Carefully
pass the wires through each rod as you assemble.
4. Thread the couplings (H) onto the top of the last
attached rod.
5. Insert the nipples of coupling (H) into holes in
canopy (D), then place metal plate (G) over the
nipples and secure with lock washers (F) and nuts
(E).
MOUNTING THE FIXTURE (FIG.1)
6. Secure mounting bracket (A) to junction box (not
provided) with junction box screws (B) (Size: #832*0.6”L) through the slotted holes in hanging
bracket (A). The side of the mounting bracket
marked “GND” must face out.
CONNECTING THE WIRES (FIG. 2)
7. At this point, connect the electrical wires as
shown in figure 2, making sure that all wire
connectors are secured. If your outlet box has a
ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect
the fixture’s ground wire directly to the mounting
bracket using the green screw provided
8. Tuck the wire connectors neatly into the ceiling
junction box.
COMPLETING THE INSTALLATION (FIG. 1)
9. Raise the canopy (D) to the mounting bracket (A),
and the secure canopy (H) with mounting screws (C)
(Size: #8-32*0.5”L).
10. Install the proper light bulb for your fixture. Install
the light bulbs (Included) in accordance with the
fixture’s specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return the power
to the junction box and test the fixture.
FiG.1
Set# A-021-192102
- Hanging bracket
- Ground screw
- Mounting screws*4
- Junction box screws*2
A
C
B
D
E
G
F
D
H
I
Side View
W30-1-84
J
K
W30-H-84
M
Fig .2
L