Minka Lavery 943-126 Installation Guide

INSTALLATION INSTRUCTIONS FOR 943-126
WARNING!
SHUT
POWER OFF AT FUSE OR
ASSEMBLY THE FIXTURE (Fig.2)
1. Attach column (B) with loop (A) to the fixture center body (C) by
turning it clockwise until tight.
2. Place the socket sleeve (D) over the socket.
3. Install the light bulbs and clip the cloth shades (E) on to the
bulbs.
HANG THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove old fixture
from ceiling, including the old crossbar.
2. Carefully unpack new fixture and lay all the parts on a clear
surface.
3. Thread nipple (C) into loop (F) until snug.
4. Thread other end of nipple (C) with loop attached into crossbar
(D) until snug.
5. Place lock washer (B) over end of nipple protruding through
crossbar and thread hex nut (A) onto nipple until tight.
6. Take this crossbar assembly and mount to ceiling junction box
with junction box screws (E). Tighten screws securely with
screwdriver.
7. Use a pair of pliers to open one end link of the chain provided
and connect to the fixture loop (J). Close the link.
8. By measuring, determine correct number of links needed for
proper hanging height. Using pliers, disconnect and discard
remaining chain.
9. Lace the fixture wires through the chain.
10. Slip loop collar (H) over the chain, then do the same with the
canopy (G).
11. Open the other end link of the chain and hang the fixture on the
loop at the ceiling . Close the link.
12. Feed the fixture wires through the loop (F) and nipple (C) and
pull until taut.
CONNECTING THE WIRES (Fig.3)
1. Take the black wire from the ceiling junction box and the smooth
wire leg from the fixture and twist bare ends together. Twist wire
connector onto end of wire until snug.
2. Repeat same process with white junction box wire and ribbed
wire leg of fixture wire. NOTE: Twist wires together in the same
direction you twist the wire connector onto wires.
3. If you junction box has a grounding wire (green or bare copper),
attach this wire and the bare copper wire from the fixture together
as step 1.If junction box has no ground wire, attach the bare
copper fixture wire to the green ground screw on the crossbar.
4. Tuck these wire connections neatly into the ceiling outlet box and
then raise the canopy (G) all the way to the ceiling. Raise the loop
(H) and thread onto ceiling loop protruding through canopy
5. Install the light bulbs in accordance with the fixture specifications
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE.
Your installation is now complete Return power to the
junction box and test the fixture.
Fig.3
Fig.1
Fig.2
CIRCUIT
BREAKER .