Minka Lavery 1577-477 Installation Guide

MEDALLION INSTALLATION GUIDE
1577-477
1
Apply polyurethane adhesive on the
back side of the medallion staying
approximately 1” away from edge.
(Polyurethane adhesive not included)
2
If required, standard or trim head
screws can be used to secure medallion
until adhesive sets. Screw heads should
be recessed. (Screws not included)
3
If any adhesive runs out during steps 1
or 2, use a wet cloth immediately to
remove the excess.
The medallion is now installed!
4
When you install the lighting fixture,
you may need to replace the threaded
nipple that comes with the lighting
fixture, with the longer threaded nipple
included with the ceiling medallion.